Massey Ferguson 04.00.2D – TRANS: Steering Column Forward/Reverse Drive Lever Issue

Steering Column Forward/Reverse Drive Lever Issue

• 7714
• 7715
• 7715S
• 7716
• 7716S
• 7718
• 7718S
• 7719
• 7720
• 7720S
• 7722
• 7722S
• 7724
• 7724S
• 7726
• 7726S
• Tier 4 (2015-2021)
• 4707
• 4708
• 4709
• 4710
• 5608
• 5609
• 5610
• 5611
• 5612
• 5613
• 5709 S
• 5710 SL
• 5711 SL
• 5712 SL
• 5713 SL
• 6612
• 6613
• 6614
• 6615
• 6616
• 7614
• 7615
• 7616
• 7618
• 7619
• 7620
• 7622
• 7624
• 7626
• 8727
• 8730
• 8732
• 8735
• 8737

1. 1

   Inspect the steering column lever wiring harness and plug connector for chafed wires, loose pins, or corrosion.

2. 2

   Use a multimeter to test the lever switch contacts, verifying correct voltage and continuity signals to the TRANS module in Forward, Neutral, and Reverse positions.

3. 3

   Check the power shuttle indirect transmission switch (neutral safety switch) on the transmission housing for failure or improper adjustment.

4. 4

   Scan the TRANS module for other speed sensor or clutch solenoid codes that might indicate a deeper hydraulic or transmission issue.

1. 1

   Disconnect Power

   Disconnect the tractor's battery to prevent electrical shorts or accidental transmission engagement during the repair.

2. 2

   Remove Steering Column Covers

   Unscrew and remove the plastic shrouds surrounding the steering column to expose the base of the shuttle lever.

3. 3

   Disconnect the Harness

   Unplug the electrical connector (typically a single multi-pin plug) from the base of the lever.

4. 4

   Remove the Lever

   Remove the mounting screws/bolts securing the lever assembly to the steering column bracket.

5. 5

   Install the New Lever

   Mount the replacement lever onto the column and secure it with the hardware.

6. 6

   Reconnect and Reassemble

   Plug the electrical connector into the new lever and reinstall the steering column covers.

7. 7

   Reconnect Battery & Clear Codes

   Reconnect the battery, turn the key on, and use a diagnostic tool to clear the 04.00.2D fault code from the TRANS module.

8. 8

   Calibration / Test Drive

   Start the tractor and test the forward, neutral, and reverse functions. Note: On some Dyna-6 and Dyna-VT models, a transmission calibration sequence may need to be triggered if shift quality is harsh after replacing transmission control components.