04.01.E5

Massey Ferguson 04.01.E5 – TRANS: Transmission Internal Software Issue

Issue description

The onboard diagnostic (OBD) system has detected a software corruption, internal memory error, or processing fault within the transmission's electronic control system. The controller is unable to properly execute its internal logic, which can lead to erratic shifting, failure to engage gears, or a complete transmission lockout.

Applies to these machines

  • 7714
  • 7715
  • 7715S
  • 7716
  • 7716S
  • 7718
  • 7718S
  • 7719
  • 7720
  • 7720S
  • 7722
  • 7722S
  • 7724
  • 7724S
  • 7726
  • 7726S
  • Tier 4 (2015-2021)
  • 7700 Series
  • 7700S Series

Check the cause

  1. Check battery voltage, alternator output, and inspect the main fuses/relays supplying power to the TRANS module (low voltage can cause software glitches)

  2. Inspect the wiring harnesses and ground connections leading to the transmission controller for corrosion, damage, or loose pins

  3. Ensure the CAN BUS lines communicating with the transmission controller are intact

  4. Connect the AGCO Electronic Diagnostic Tool (EDT) to read the active/inactive status of the code and attempt to clear it

Repair steps

  1. Clear the Code

    Using the AGCO EDT, attempt to clear the 04.01.E5 fault code. Cycle the tractor's key switch and operate the transmission to see if the code returns.

  2. Software Reflash/Update

    If the code returns and wiring/voltage checks pass, the issue is strictly software-related. Use the AGCO EDT to check for available software updates for the Transmission Control Unit. Reflash the TCU with the latest OEM software.

  3. Recalibration

    After a successful reflash, perform a full transmission calibration (clutch pedal, drive pedal, and transmission turbo clutch calibration) as required by the software update.

  4. Module Replacement

    If the AGCO EDT cannot communicate with the module, the software flash fails, or the code immediately returns after a successful flash, the internal memory (hardware) of the TCU has failed. The Transmission Control Unit must be physically replaced and programmed to the tractor.

Parts you might need

(2)
  • Autotronic 5 Unit - 2x CAN

    MAMFFF00035

    Must be programmed/calibrated by an authorized dealer using the AGCO EDT software. Rebuild services are also available.

  • Vario Transmission Control Unit

    MAFEFF00031

    Must be programmed/calibrated by an authorized dealer using the AGCO EDT software. Rebuild services are also available.

Get help to fix this fault by requesting a quote

Browse other Massey Ferguson codes