Massey Ferguson 04.03.19 – TRANS: Issue With The Stored Values For The Foot Throttle (TRANS)

The controller has lost, corrupted, or is reading invalid calibration data regarding the minimum and maximum travel positions of the foot throttle pedal potentiometer. Without these stored values, the tractor cannot accurately determine the operator's requested engine speed or acceleration.

• 7714
• 7715
• 7715S
• 7716
• 7716S
• 7718
• 7718S
• 7719
• 7720
• 7720S
• 7722
• 7722S
• 7724
• 7724S
• 7726
• 7726S
• Tier 4 (2015-2021)
• 7700 series
• 7700S series
• 4700 series
• 5600 series
• 5700SL series
• 7600 series

1. 1

   Check for Accompanying Codes: Look for related voltage codes such as 04.03.20 or 04.03.22 (Issue With Signal Voltage From Foot Throttle Sensor). If these are present, the issue is likely a hard electrical failure (wiring or sensor) rather than just a calibration loss.

2. 2

   Inspect Wiring and Connections: Check the wiring harness and connector at the foot throttle pedal for corrosion, loose pins, or physical damage.

3. 3

   Check Battery/System Voltage: A weak battery or low system voltage can cause the transmission module to lose its stored calibration values.

1. 1

   Inspect and Test

   Verify the physical condition of the foot throttle pedal. Ensure there is no debris blocking its full range of motion.

2. 2

   Replace if Faulty

   If the sensor has failed electrically (indicated by accompanying voltage codes that do not clear after wiring checks), remove the mounting hardware and disconnect the wiring harness to replace the foot throttle pedal assembly.

3. 3

   Recalibrate the Pedal

   Recalibrate the pedal so the Transmission module can relearn the idle and wide-open throttle positions. This is done via the SIS (System Information Screen) / Datatronic monitor, or by a dealer using the AGCO diagnostic tool.

4. 4

   Clear Codes

   Once calibration is complete, use the diagnostic tool or monitor to clear the DTCs from the system and test drive the tractor to ensure normal acceleration.