04.03.56

Massey Ferguson 04.03.56 – TRANS: Transmission Filter Blockage Sensor Issue

Issue description

The onboard diagnostic system has detected an irregularity, signal error, or malfunction specifically related to the sensor responsible for monitoring the transmission/hydraulic oil filter for blockages (Sensor X20). The sensor itself is sending a faulty signal, has a wiring issue, or is being triggered by a genuinely clogged filter.

Applies to these machines

  • 7714
  • 7715
  • 7715S
  • 7716
  • 7716S
  • 7718
  • 7718S
  • 7719
  • 7720
  • 7720S
  • 7722
  • 7722S
  • 7724
  • 7724S
  • 7726
  • 7726S
  • Tier 4 (2015-2021)
  • 7700 Series
  • 7700S Series

Check the cause

  1. Check transmission/hydraulic oil fluid levels and condition for heavy contamination, metal filings, or degraded oil

  2. Inspect the transmission filter to see if it is genuinely blocked or due for its 1200-hour service interval

  3. Test Sensor X20 (Transmission filter blockage sensor) and inspect its wiring harness and connector for corrosion, loose connections, or broken wires

Repair steps

  1. Park the tractor on a level surface, turn off the engine, and engage the parking brake.

  2. Locate the transmission filter and the Transmission Filter Blockage Sensor (X20).

    Typically mounted on the side of the gearbox/transmission housing.

  3. Disconnect the electrical connector from Sensor X20 and inspect the pins for damage or debris.

  4. If the filter is suspected to be blocked or is due for a service interval, place a drain pan underneath, remove the old transmission filter, and install a new genuine Massey Ferguson filter.

  5. Top up the transmission fluid with approved Massey Ferguson hydraulic/transmission fluid to replace any lost during the filter change.

  6. If the filter is clean but the sensor is confirmed faulty, unscrew Sensor X20 from the housing and install a new replacement sensor.

  7. Reconnect the wiring harness to the sensor.

  8. Start the tractor and check for leaks around the filter and sensor housing.

  9. Use a specialized Massey Ferguson diagnostic tool to clear the 04.03.56 DTC from the TRANS module.

Parts you might need

(6)
  • Transmission Filter Blockage Sensor / Switch

    OEM part number varies by specific model (Referenced in schematics as component X20)

  • Transmission Suction Filter

    3790002M1

    Fits many Dyna-4 and Dyna-6 models including 7718 S

  • Hydraulic Filter

    4382525M1

    Common for Dyna-VT / Vario transmissions in the 6700S and 7700S series

  • Hydraulic Filter Element

    4312614M2

    Fits various 5400, 6400, 7600, and 7700 series

  • Hydraulic Filter Element

    4306300M1

    Fits various 5400, 6400, 7600, and 7700 series

  • Transmission / Hydraulic Fluid

    Massey Ferguson approved

Get help to fix this fault by requesting a quote

Browse other Massey Ferguson codes