Massey Ferguson 08.02.1C – HITCH: Rear Hitch Raise/Lower Rocker Switch Signal Issue (HITCH)

The tractor's onboard diagnostic system has detected an irregular, missing, or out-of-range electrical signal coming from the rocker switch used to control the up and down movement of the rear three-point hitch.

• 7724S
• 5712SL
• 7722
• 7722S
• 5713SL
• 7720S
• 7716
• 7718
• T4
• 7715
• 5710SL
• 7726
• 7726S
• 5711SL
• 7718S
• 7719
• 7714
• 7716S
• 7720
• Tier 4 (2015-2021)
• 7715S
• 7724
• 5608
• 5609
• 5610
• 5611
• 5612
• 5613

1. 1

   Ensure the tractor is turned off, the hydraulic system is depressurized, and the rear hitch is fully lowered to the ground or mechanically supported

2. 2

   Inspect the cab console rocker switch for physical damage, sticking, or heavy accumulation of dust/moisture

3. 3

   Remove the switch from the console and inspect the wiring harness connector for loose pins, frayed wires, or corrosion

4. 4

   Use a multimeter to test the switch's electrical contacts (3-position On/Off/On) to verify it sends correct voltage signals when toggled and returns to an open/neutral state when released. If the switch tests fine, the issue may be a break in the wiring harness between the switch and the HITCH module.

1. 1

   Shut down the tractor, lower the rear hitch, and disconnect the battery

   This prevents electrical shorts.

2. 2

   Locate the rear hitch raise/lower rocker switch

   It is located on the right-hand cab console panel.

3. 3

   Carefully pry the switch or the surrounding bezel out of the console panel

   Most OEM switches are direct drop-in designs held in by plastic retention clips.

4. 4

   Disconnect the wiring harness plug

   Remove it from the back of the faulty switch.

5. 5

   Plug the tractor's wiring harness directly into the new replacement switch

   No modifications should be necessary for OEM replacements.

6. 6

   Snap the new switch firmly back into the console panel

7. 7

   Reconnect the battery, start the tractor, and test the up/down function of the three-point hitch

   Ensure the fault code clears and the linkage responds smoothly.