Massey Ferguson 09.02.02 – HITCH: Front Hitch External Control Buttons Signal Issue (HITCH)

The electronic control unit has detected an invalid signal, open circuit, or short circuit coming from the external push buttons or toggle switches used to raise and lower the front 3-point hitch from outside the cab (usually located on the front grille or mudguard area).

• 7724S
• 5712SL
• 7722
• 7722S
• 5713SL
• 7720S
• 7716
• 7718
• T4
• 7715
• 5710SL
• 7726
• 7726S
• 5711SL
• 7718S
• 7719
• 7714
• 7716S
• 7720
• Tier 4 (2015-2021)
• 7715S
• 7724
• 5608
• 5609
• 5610
• 5611
• 5612
• 5613
• 7614
• 7615
• 7616
• 7618
• 7619
• 7620
• 7622
• 7624
• 7626

1. 1

   Visually inspect the external front hitch control buttons for physical damage, sticking, or heavy moisture and dirt ingress from weather or pressure washing.

2. 2

   Trace the wiring harness from the back of the front hitch switches to the main harness, looking for chafed wires, breaks, or pinch points near the front axle and grille.

3. 3

   Disconnect the switch and inspect the connector pins for green corrosion or bent terminals.

4. 4

   Test the switch for continuity using a multimeter. It should show an open circuit at rest and a closed circuit (or specific resistance) when pressed. A short to ground or no continuity indicates internal failure.

5. 5

   Verify the external switch activation sequence (e.g., pressing up, down, up, down, then holding the up button) has been performed correctly, as this is required on many models before the switches will respond.

1. 1

   Disconnect Power

   Turn off the tractor and disconnect the negative battery terminal to prevent electrical shorts during repair.

2. 2

   Access the Switch

   Locate the faulty external hitch switch on the front grille or mudguard. You may need to remove a plastic bezel or access panel behind the grille to reach the rear of the switch.

3. 3

   Disconnect the Harness

   Unplug the electrical connector from the back of the switch.

4. 4

   Remove the Switch

   Depress the retaining tabs or remove the locking nut holding the switch in its housing, and push the switch out through the front of the panel.

5. 5

   Install the New Switch

   Snap the new OEM switch into the panel until it locks securely in place.

6. 6

   Reconnect

   Plug the wiring harness back into the switch. Ensure the weather-tight seal on the connector is intact. Reconnect the battery.

7. 7

   Clear Codes and Test

   Turn the key on. Clear the DTC 09.02.02 using a compatible diagnostic tool. Perform the external switch activation sequence and test the front hitch for proper up/down operation.