Massey Ferguson 0A.2X.2A – Dash / Mid Mount Valve Module: External Hydraulic Valve 2 Issue

Indicates a fault within the hydraulic control system, specifically targeting the second external hydraulic remote/spool valve. Typically caused by a connection problem on the hydraulic valve or an issue with the spool position sensor value.

• 7724S
• 5712SL
• 7722
• 7722S
• 5713SL
• 7720S
• 7716
• 7718
• T4
• 7715
• 5710SL
• 7726
• 7726S
• 5711SL
• 7718S
• 7719
• 7714
• 7716S
• 7720
• Tier 4 (2015-2021)
• 7715S
• 7724
• 4707
• 4708
• 4709
• 4710
• 5608
• 5609
• 5610
• 5611
• 5612
• 5613
• 7614
• 7615
• 7616
• 7618
• 7619
• 7620
• 7622
• 7624
• 7626

1. 1

   Use a compatible Massey Ferguson diagnostic tool or interface device to confirm the code and check for secondary codes (like M16, M17, M21, or 0A.41.FF)

2. 2

   Check the physical wiring harness and connectors leading to External Hydraulic Valve 2 for connection problems

3. 3

   Check the spool position sensor values via the diagnostic tool to see if the sensor is reading out of range or failing to communicate

4. 4

   Verify the CAN bus/communication lines between the Dash display and the Valve Module

1. 1

   Disconnect the battery/power before servicing the hydraulic electrical connections.

   Ensure power is removed to safely service the hydraulic electrical connections.

2. 2

   Clean and reseat the electrical connector on External Hydraulic Valve 2.

   Look for corrosion, bent pins, or wire chafing.

3. 3

   Replace the spool position sensor on Valve 2.

   Perform this step if the wiring is intact but the code persists, indicating the sensor is likely faulty.

4. 4

   Replace the external hydraulic valve actuator.

   Perform this step if the spool position sensor is integrated into the valve actuator.

5. 5

   Clear the DTCs using the diagnostic interface and cycle the hydraulic valve.

   Ensure the code does not return after cycling the valve.