0A.40.28

Massey Ferguson 0A.40.28 – Chassis/Implement ECU or Transmission controller: External Hydraulic Valve 4 Issue

Issue description

Indicates a fault or malfunction associated with the 4th external hydraulic remote valve (spool valve) on the tractor. The underlying condition is often electrical or communication-based at the valve's solenoid or connector.

Applies to these machines

  • 7724S
  • 5712SL
  • 7722
  • 7722S
  • 5713SL
  • 7720S
  • 7716
  • 7718
  • T4
  • 7715
  • 5710SL
  • 7726
  • 7726S
  • 5711SL
  • 7718S
  • 7719
  • 7714
  • 7716S
  • 7720
  • Tier 4 (2015-2021)
  • 7715S
  • 7724
  • 4707
  • 4708
  • 4709
  • 4710
  • 5608
  • 5609
  • 5610
  • 5611
  • 5612
  • 5613
  • 7614
  • 7615
  • 7616
  • 7618
  • 7619
  • 7620
  • 7622
  • 7624
  • 7626

Check the cause

  1. Inspect the electrical connector at External Hydraulic Valve 4 for corrosion, bent pins, or moisture ingress.

  2. Verify the continuity of the wiring between the valve solenoid and the tractor's wiring harness.

  3. Test the solenoid on Valve 4 to ensure it is receiving proper voltage when actuated from the cab.

  4. Use a compatible diagnostic tool to clear the code and cycle the hydraulic valve to see if the code returns as an active fault.

Repair steps

  1. Relieve pressure

    Ensure the tractor is turned off and hydraulic pressure is fully relieved.

  2. Remove bolts

    Remove the bolts securing the cap/plate on the hydraulic lift cover.

  3. Detach cap

    Detach the cap from the standpipe, ensuring the standpipe is not dislodged from its seat in the hydraulic pump.

  4. Disconnect harness

    Disconnect the electrical harness from the faulty External Hydraulic Valve 4.

  5. Remove valve

    Remove the bolts securing the faulty valve to the base plate.

  6. Install new valve

    Fit the new control valve to the base plate, ensuring the standpipe is correctly located into its seat.

  7. Secure and reconnect

    Secure the new valve with the mounting bolts and reconnect the electrical harness.

  8. Test operation

    Top off hydraulic fluid if any was lost, start the tractor, and test the remote for proper operation and leakages.

Parts you might need

(8)
  • Hydraulic Selector/Diverter Valve

    180908M1

    OEM Reference Number

  • Hydraulic Selector/Diverter Valve

    1860100M95

    OEM Reference Number

  • Hydraulic Selector/Diverter Valve

    1696239M92

    OEM Reference Number

  • Sparex Single Section Control Valve

    S.165654

    3/8'' BSP

  • Sparex Twin Section Control Valve

    S.165655

    3/8'' BSP

  • Hydro-Pack Special Control Valve

    P510

    2 outlets

  • Hydro-Pack Special Control Valve

    P625

    4 outlets

  • External Hydraulic Remote Valve / Spool Valve

    Generic Part Name

Get help to fix this fault by requesting a quote

Browse other Massey Ferguson codes