Massey Ferguson 0A.60.11 – Onboard diagnostic system: External Hydraulic Valve 6 Issue

Indicates a malfunction associated with the 6th external hydraulic remote valve (spool valve), potentially an electrical connection problem.

• 7724S
• 5712SL
• 7722
• 7722S
• 5713SL
• 7720S
• 7716
• 7718
• T4
• 7715
• 5710SL
• 7726
• 7726S
• 5711SL
• 7718S
• 7719
• 7714
• 7716S
• 7720
• Tier 4 (2015-2021)
• 7715S
• 7724
• 4707
• 4708
• 4709
• 4710
• 5608
• 5609
• 5610
• 5611
• 5612
• 5613
• 7614
• 7615
• 7616
• 7618
• 7619
• 7620
• 7622
• 7624
• 7626

1. 1

   Verify the hydraulic fluid (UTTO) level and condition. Ensure the hydraulic filters have been changed within the last 300-500 hours, as contaminated fluid can cause valve malfunctions.

2. 2

   Inspect the external hydraulic valve block (specifically Valve 6) for visible leaks, damaged hoses, or faulty quick couplers.

3. 3

   Inspect the wiring harness and electrical connector leading to Valve 6. Look for corrosion, broken wires, or loose connections that would interrupt the signal from the cab controls.

4. 4

   If the fluid is heavily contaminated, flush the system before installing a new valve to prevent immediate failure of the replacement part.

1. 1

   Preparation

   Park the tractor on a level surface, lower all implements to the ground, and turn off the engine.

2. 2

   Relieve pressure

   Cycle the hydraulic control levers/buttons in the cab to relieve any residual hydraulic pressure in the system.

3. 3

   Locate the valve

   Locate the rear external hydraulic valve stack and identify the 6th spool valve assembly.

4. 4

   Disconnect electricals

   Carefully unplug the electrical wiring harness connector from the valve's solenoid.

5. 5

   Remove hoses

   Place a catch pan underneath the valve block. Disconnect the hydraulic lines and couplers attached to Valve 6.

6. 6

   Remove the valve

   Unbolt the valve assembly from the hydraulic manifold/stack.

7. 7

   Replace or rebuild

   Install a new electronic spool valve or rebuild the existing one using an OEM seal/O-ring kit.

8. 8

   Reinstallation

   Bolt the new/repaired valve back onto the stack. Reconnect the hydraulic lines and plug in the electrical connector.

9. 9

   Fluid top-up and testing

   Top up the hydraulic fluid with OEM-spec UTTO fluid. Start the tractor, allow the system to warm up, and test the valve's operation while checking for leaks.

10. 10

    Clear codes

    Use a compatible diagnostic tool to clear the 0A.60.11 code from the system.