Massey Ferguson 0A.60.1E: External Hydraulic Valve 6 Issue

Indicates a malfunction, connection problem, or performance failure associated with the 6th external hydraulic remote valve (spool valve) on the tractor. This can result in a drop in hydraulic pressure, slow response times, or jerky/erratic movements when trying to control attachments.

• 7724S
• 5712SL
• 7722
• 7722S
• 5713SL
• 7720S
• 7716
• 7718
• T4
• 7715
• 5710SL
• 7726
• 7726S
• 5711SL
• 7718S
• 7719
• 7714
• 7716S
• 7720
• Tier 4 (2015-2021)
• 7715S
• 7724
• 4707
• 4708
• 4709
• 4710
• 5608
• 5609
• 5610
• 5611
• 5612
• 5613
• 7614
• 7615
• 7616
• 7618
• 7619
• 7620
• 7622
• 7624
• 7626

1. 1

   Verify the hydraulic fluid (UTTO) level and condition, looking for contamination such as metal shavings or dust, and ensure the filter was changed within the last 300-500 hours.

2. 2

   Inspect the external hydraulic valve 6, hoses, couplers, and seals for visible leaks or physical damage.

3. 3

   Check the wiring harness and electrical connectors going to the electric spool slice/valve for broken wires, corroded pins, or loose plugs.

4. 4

   Perform an operational test manually or via cab controls to determine if the valve is physically stuck or if the issue is purely electrical.

1. 1

   Depressurize the System

   Turn off the tractor and actuate the hydraulic levers/controls to relieve all residual hydraulic pressure before beginning work.

2. 2

   Drain/Flush Fluid (If Contaminated)

   If the diagnostic check revealed contaminated fluid, drain the hydraulic fluid and replace the hydraulic filter.

3. 3

   Disconnect Valve

   Disconnect the electrical harness plugged into External Hydraulic Valve 6.

4. 4

   Remove the Valve

   Unbolt the hydraulic lines connected to the valve, capping them to prevent contamination. Unbolt the spool slice from the valve bank.

5. 5

   Rebuild or Replace

   Depending on the diagnosis, either rebuild the valve using an OEM repair kit (replacing internal seals and O-rings) or install a completely new electric spool slice.

6. 6

   Reinstall

   Bolt the new/rebuilt valve back into the valve bank. Reconnect the hydraulic lines and plug in the electrical connector.

7. 7

   Programming

   If replacing an electric spool slice on modern series tractors, the new valve unit must be programmed to the tractor's ECU using a compatible diagnostic tool.

8. 8

   Test

   Refill the system with clean UTTO hydraulic fluid, start the tractor, and test the remote valve for proper operation and leak-free performance.