Massey Ferguson 0A.60.26 – VCM: External Hydraulic Valve 6 Issue

Fault code 0A.60.26 indicates a malfunction, electrical fault, or communication error specifically isolated to the 6th external hydraulic remote/spool valve. This code suggests an electrical circuit issue, a sticking spool, or a failed solenoid on Valve 6, which can disrupt hydraulic operations.

• 7724S
• 5712SL
• 7722
• 7722S
• 5713SL
• 7720S
• 7716
• 7718
• T4
• 7715
• 5710SL
• 7726
• 7726S
• 5711SL
• 7718S
• 7719
• 7714
• 7716S
• 7720
• Tier 4 (2015-2021)
• 7715S
• 7724
• 4707
• 4708
• 4709
• 4710
• 5608
• 5609
• 5610
• 5611
• 5612
• 5613
• 7614
• 7615
• 7616
• 7618
• 7619
• 7620
• 7622
• 7624
• 7626

1. 1

   Verify the hydraulic fluid level and condition. Low or contaminated fluid can cause valve sticking.

2. 2

   Inspect the wiring harness and electrical connector going to External Hydraulic Valve 6 for frayed wires, corrosion, or loose pins.

3. 3

   Check the valve block for external leaks and attempt to operate it manually (if equipped with a manual override) to determine if the spool is physically jammed.

4. 4

   Use a compatible diagnostic tool to clear the DTC and cycle the tractor's hydraulics to see if the code returns immediately (hard electrical fault) or during operation (mechanical/pressure issue).

1. 1

   Depressurize the system

   Turn off the tractor and actuate the hydraulic levers/controls to relieve all residual pressure in the hydraulic system.

2. 2

   Clean the area

   Thoroughly clean the area around the external hydraulic valve block to prevent dirt from entering the hydraulic system.

3. 3

   Disconnect electricals

   Unplug the wiring harness connector from Valve 6.

4. 4

   Remove hydraulic lines

   Disconnect the hydraulic hoses/lines attached to the valve. Cap the lines immediately to prevent fluid loss and contamination.

5. 5

   Dismount the valve

   Remove the mounting bolts securing Valve 6 to the main hydraulic distribution block or lift cover.

6. 6

   Repair or replace valve

   If rebuilding, disassemble the valve and use an OEM spool valve repair kit to replace the internal O-rings and seals. If replacing, mount the new electronic spool valve assembly.

7. 7

   Reassemble components

   Torque the mounting bolts to OEM specifications, reconnect the hydraulic lines, and plug in the electrical connector.

8. 8

   Test system

   Top off the hydraulic fluid, start the tractor, check for leaks, and test the operation of Valve 6. Clear the fault code with a diagnostic tool.