Massey Ferguson 0A.62.24 – Tractor ECU: External Hydraulic Valve 6 Issue

A malfunction within the circuit or mechanical operation of the 6th auxiliary hydraulic remote valve (spool valve), likely indicating an electrical continuity, solenoid, or communication failure at the valve.

• 7724S
• 5712SL
• 7722
• 7722S
• 5713SL
• 7720S
• 7716
• 7718
• T4
• 7715
• 5710SL
• 7726
• 7726S
• 5711SL
• 7718S
• 7719
• 7714
• 7716S
• 7720
• Tier 4 (2015-2021)
• 7715S
• 7724
• 4707
• 4708
• 4709
• 4710
• 5608
• 5609
• 5610
• 5611
• 5612
• 5613
• 7614
• 7615
• 7616
• 7618
• 7619
• 7620
• 7622
• 7624
• 7626

1. 1

   Locate the #6 external hydraulic valve at the rear remote stack and perform a visual inspection

2. 2

   Inspect the electrical connector at the valve for corrosion, pushed-out pins, or moisture intrusion

3. 3

   Trace the wiring harness from the valve back toward the ECU to check for chafing, breaks, or rodent damage

4. 4

   Use a compatible Massey Ferguson diagnostic interface device to retrieve the code, monitor live data for the #6 valve, and confirm if the fault is active or stored

1. 1

   Disconnect Power

   Turn off the tractor and disconnect the battery to prevent electrical shorts during repair.

2. 2

   Isolate the Fault

   If the wiring and connector are intact, swap the electrical connection from Valve 6 to an adjacent valve (e.g., Valve 5) if the harness allows. If the fault code moves to the new valve, the issue is in the wiring/ECU. If the fault remains at Valve 6, the valve solenoid or internal spool mechanism is faulty.

3. 3

   Remove the Valve

   Depressurize the hydraulic system. Disconnect the hydraulic lines and electrical connector to the #6 auxiliary remote valve. Unbolt the valve from the rear hydraulic stack.

4. 4

   Replace or Repair

   Install a replacement external hydraulic valve (or replace the electronic solenoid head if available separately).

5. 5

   Reassemble and Clear Codes

   Reattach hydraulic lines and electrical connectors. Reconnect the battery. Use a compatible diagnostic tool to clear the 0A.62.24 code from the system.

6. 6

   Test

   Run the tractor and actuate the #6 remote to ensure proper hydraulic flow and verify the code does not return.