0A.6X.11

Massey Ferguson 0A.6X.11: External Hydraulic Valve 6 Issue

Issue description

Indicates a fault, likely electrical or connection-related, within the circuit or operation of the 6th external hydraulic remote valve.

Locate External Hydraulic Valve 6 at the rear remote valve stack.
Inspect the electrical connector at the valve solenoid for corrosion, moisture, or backed-out pins.
Trace the wiring harness from Valve 6 back to the main chassis harness, looking for chafing, breaks, or rodent damage.
Use a digital multimeter to verify voltage and ground at the valve connector when the remote is commanded from the cab.

Disconnect the battery before servicing the electrical connections.
If the wiring harness is damaged, repair the broken wires using weather-sealed splice connectors, or replace the affected harness section.
If the connector is corroded, clean the pins with electrical contact cleaner and apply dielectric grease.
If the wiring is intact but the valve fails to actuate or continues to throw the code, replace the hydraulic valve solenoid or the entire external hydraulic valve assembly.
Clear the DTCs using a compatible Massey Ferguson diagnostic tool or interface device.

(6)

External hydraulic valve kit, single spool, double-acting control valve
TS3200M
Includes isolator valve, couplers, clamp, hoses, adapters, and hardware
TS3200M

External Hydraulic Valve Solenoid / External Hydraulic Remote Valve Assembly
Generic Part Name

Get help to fix this fault by requesting a quote