Massey Ferguson 0B.X.20 – Mid Mount Valve Module: Issue With Spool Position Sensor Value

The onboard diagnostic system is receiving an irregular, out-of-range, or missing signal from the spool position sensor, which monitors the position of the electro-hydraulic valves.

• 5710SL
• 5711SL
• 5712SL
• 5713SL
• T4
• 5608
• 5609
• 5610
• 5611
• 5612
• 5613
• 4707
• 4708
• 4709
• 4710
• 7614
• 7615
• 7616
• 7618
• 7619
• 7620
• 7622
• 7624
• 7626
• 7714
• 7715
• 7715S
• 7716
• 7716S
• 7718
• 7718S
• 7719
• 7720
• 7720S
• 7722
• 7722S
• 7724
• 7724S
• 7726
• 7726S

1. 1

   Verify the wiring harness and connectors between the Dash and the Mid Mount Valve Module for connection problems

2. 2

   Look for accompanying codes indicating an open circuit, low amp draw, or high amp draw on the Loader Mid Mount Electro Valve Solenoids

3. 3

   Check if the valves require calibration (look for codes 0B.X.22 and 0B.X.23)

4. 4

   Retrieve and clear codes using a compatible diagnostic tool to see if the issue is a hard fault or an intermittent glitch

1. 1

   Consult service manual

   Consult the tractor's specific service manual for instructions on accessing the Mid Mount Valve Module.

2. 2

   Inspect sensor

   Inspect the spool position sensor on the affected mid-mount valve for physical damage or debris.

3. 3

   Replace sensor

   Replace the faulty spool position sensor if the value remains out of range.

4. 4

   Calibrate valves

   Perform a valve calibration procedure (as indicated by related calibration fault codes) once the new sensor is installed.

5. 5

   Clear DTCs

   Clear the DTCs using the tractor's manual instructions or a specialized diagnostic tool.