Massey Ferguson 10.00.16 – AIRCON: Air Conditioning Panel Module Internal Issue With Temperature Dial (AIRCON)

This code indicates an internal hardware or circuit failure within the cab's climate control panel, specifically related to the temperature adjustment dial (likely a failed potentiometer or internal board fault).

• 7724S
• 5712SL
• 7722
• 7722S
• 5713SL
• 7720S
• 7716
• 7718
• T4
• 7715
• 5710SL
• 7726
• 7726S
• 5711SL
• 7718S
• 7719
• 7714
• 7716S
• 7720
• Tier 4 (2015-2021)
• 7715S
• 7724
• 4707
• 4708
• 4709
• 4710
• 5608
• 5609
• 5610
• 5611
• 5612
• 5613
• 5708
• 5709
• 6612
• 6613
• 6614
• 6615
• 6616
• 7614
• 7615
• 7616
• 7618
• 7619
• 7620
• 7622
• 7624
• 7626
• 8450
• 8460

1. 1

   Inspect the temperature dial on the AC control panel. Check if it feels loose, binds, or is physically broken.

2. 2

   Remove the panel trim and inspect the wiring harness connectors at the rear of the AC module. Look for loose pins, corrosion, or damaged wires that could cause a loss of signal.

3. 3

   Clear the fault code using a diagnostic tool and cycle the tractor's ignition. If the code immediately returns and the wiring is intact, the fault is confirmed to be an internal module failure.

1. 1

   Disconnect Power

   Turn off the tractor and disconnect the negative battery cable to prevent electrical shorts.

2. 2

   Remove Trim

   Carefully pry off or unscrew the interior cab trim/bezel surrounding the side-mounted or dash-mounted climate control panel.

3. 3

   Extract the Module

   Remove the mounting screws securing the AC control panel to the console.

4. 4

   Disconnect Harness

   Pull the panel forward and unplug the electrical harness connectors from the back of the unit.

5. 5

   Install New Panel

   Connect the wiring harnesses to the new OEM AC control panel.

6. 6

   Reassembly

   Secure the new panel with the mounting screws and snap the trim/bezel back into place.

7. 7

   Test

   Reconnect the battery, turn on the tractor, and clear the stored 10.00.16 fault code. Test the HVAC system to ensure the temperature dial responds correctly.