00102.00

Massey Ferguson 00102.00 – ECU: Intake Boost Pressure Sensor Signal Too High

Issue description

The Engine Control Unit (ECU) has detected a voltage signal from the intake boost pressure sensor that is above the normal operating threshold. This indicates a potential issue with the sensor itself, its circuit, or the turbocharger system. Because the ECU uses this data to regulate fuel delivery and turbocharger performance, a signal that is too high can lead to reduced engine power, increased fuel consumption, and the engine entering a limp mode to prevent damage.

Applies to these machines

  • 4707
  • 4708
  • 4709
  • 4710
  • 5608
  • 5609
  • 5610
  • 5611
  • 5612
  • 5613
  • 5710SL
  • 5711SL
  • 5712SL
  • 5713SL
  • 7700 Series

Check the cause

  1. Visually inspect the intake boost pressure sensor, its connector, and wiring harness for damage, corrosion, loose connections, or oil/soot contamination

  2. Check for other active or stored fault codes using a diagnostic tool

  3. Verify the sensor signal with a scan tool (ignition on, engine off); it should read atmospheric pressure (approximately 14.7 PSI at sea level)

  4. Check the sensor voltage by disconnecting the connector (ignition on) and using a multimeter to verify a 5-volt reference signal from the ECU, and check the ground circuit for high resistance

  5. Compare the scan tool boost reading with a mechanical boost gauge connected to the intake manifold to confirm sensor accuracy

Repair steps

  1. Address wiring issues

    If any wiring is found to be damaged, corroded, or loose, repair or replace the affected sections of the harness. Ensure the connector is clean and makes a secure connection.

  2. Replace the sensor

    If diagnostic checks point to a faulty sensor, disconnect the negative battery terminal and electrical connector. Remove the mounting bolt(s), install the new sensor on the intake manifold, tighten to manufacturer's specified torque, and reconnect.

  3. Clear fault codes

    After the repair is complete, use a diagnostic scan tool to clear the fault code from the ECU.

  4. Test drive

    Perform a test drive, putting the engine under load to ensure that the fault code does not reappear and that the engine is performing as expected.

Parts you might need

(2)
  • Supersedes V836666980. Fits a wide range of series including 3600, 4600, 4700, 5400, 5600, 5700, 6400, 6600, 6700, 7400, 7600, 7700, and 8700, as well as several combine models.

  • Specifically mentioned for the Massey Ferguson 5700 Series and various Fendt models.

Get help to fix this fault by requesting a quote

Browse other Massey Ferguson codes