Massey Ferguson 105 – ECU: High Inlet Manifold Temperature Sensor Fault
Issue description
The Engine Control Unit (ECU) has detected a voltage signal from the inlet manifold temperature sensor that is abnormally high (typically above 4.95 or 5.13 VDC). This indicates a circuit issue, such as an open circuit or a short to a high voltage source, rather than a genuinely high air temperature. As a result, the ECU may default to a pre-set intake air temperature value and cause the cooling fan to operate continuously.
Applies to these machines
2 machines- 7600 Series
- 8600 Series
Check the cause
Record the exact fault code (including FMI 3) and the conditions under which it occurs.
Check for other active fault codes, as multiple codes may indicate a shared ground or return wire issue.
Visually inspect the intake manifold temperature sensor, connector, and wiring harness for damage, corrosion, chafing, or breaks.
Disconnect the sensor and inspect the connector pins for moisture or corrosion, ensuring it latches securely.
Check the sensor's electrical connector for a 5-volt reference supply from the ECU with the ignition on.
Test the sensor's resistance with a multimeter (nominal values: 2.5 kΩ at 20°C / 68°F; 186 Ω at 100°C / 212°F).
Perform a circuit integrity test to check for an open ground wire or a short to power on the signal wire.
Repair steps
De-energize the system
Turn off the tractor and disconnect the battery before beginning any repair work to prevent electrical damage.
Locate the sensor
Find the intake manifold temperature sensor in the air intake manifold. Note that it may be integrated into the boost pressure sensor housing.
Repair wiring harness
If the circuit integrity test reveals damaged wiring, an open ground, or a short to power, repair or replace the affected section of the harness. Ensure all connections are secure and insulated.
Replace the sensor
If resistance tests confirm the sensor is faulty, disconnect the electrical connector, unthread the old sensor, and install the new one to the correct torque specification.
Clear codes and verify
Reconnect the battery, start the engine, clear the fault code with a diagnostic tool, and operate the tractor under previous fault conditions to ensure the code does not return.
Parts you might need
(3)- Air Intake Temperature & Boost SensorV837073934
Referenced for AGCO Power EEM4 engines. Verify fitment by serial number.
- Temperature Sender Air Intake4226446M91
OEM Massey Ferguson part. Verify fitment by serial number.
- Temperature Sensor3618249M3
AGCO Parts temperature sensor. Verify fitment by serial number.
Get help to fix this fault by requesting a quote