3361.31

Massey Ferguson 3361.31 – Engine ECU: DEF Injector Has Not Opened Or Closed As Expected

Issue description

The Engine Control Unit (ECU) commanded the Diesel Exhaust Fluid (DEF) dosing injector to open, but it did not detect the expected pressure drop in the DEF system. This indicates that fluid is not actually being injected into the exhaust stream, usually due to a blockage, a stuck injector, or a lack of fluid pressure.

Applies to these machines

  • 4710
  • 7724S
  • 5712SL
  • 7722S
  • 7722
  • 5713SL
  • 7720S
  • 7716
  • 7718
  • T4
  • 7715
  • 5710SL
  • 7726
  • 4708
  • 7726S
  • 4707
  • 4709
  • 5711SL
  • 7718S
  • 7719
  • 7714
  • 7716S
  • T4 (2015-2021)
  • 7720
  • Tier 4 (2015-2021)
  • 7715S
  • 7724
  • 5608
  • 5609
  • 5610
  • 5611
  • 5612
  • 5613
  • 5710 SL
  • 5711 SL
  • 5712 SL
  • 5713 SL
  • 7614
  • 7615
  • 7616
  • 7618
  • 7619
  • 7620
  • 7622
  • 7624
  • 7626
  • 7714 S
  • 7715 S
  • 7716 S
  • 7718 S
  • 7719 S
  • 7720 S
  • 7722 S
  • 7724 S
  • 7726 S
  • 8650
  • 8660
  • 8670
  • 8680
  • 8690

Check the cause

  1. Inspect the injector tip and nozzle for DEF crystallization buildup that could be blocking the spray

  2. Check DEF fluid quality to ensure it is not contaminated with dirt, debris, or non-ISO-compliant fluid

  3. Inspect the DEF lines between the DEF pump and the injector for blockages, kinks, or leaks that would prevent pressure from reaching the injector

  4. Verify the electrical connections and wiring harness to the DEF dosing module are secure and free of corrosion or damage

Repair steps

  1. Clean or Flush

    If crystallization is found on the injector tip, clean it carefully. If the DEF fluid is contaminated, drain the tank, flush the system, and replace the DEF filters.

  2. Replace the Injector

    If the injector is mechanically stuck closed, internally damaged, or fails to open after cleaning, replace the DEF Dosing Module/Injector.

  3. System Calibration

    After replacing the dosing unit, use a diagnostic tool to clear the fault codes and run a forced DEF dosing test or system calibration. This verifies that the ECU can now detect the proper pressure drop when the injector is commanded open.

Parts you might need

(4)
  • DEF Injector / AdBlue Dosing Module

    V837074845

    OEM part (depending on the specific tractor series)

  • DEF Injector / AdBlue Dosing Module

    V837073772

    OEM part (depending on the specific tractor series)

  • DEF Injector / AdBlue Dosing Module

    V837072107

    OEM part (depending on the specific tractor series)

  • DEF Injector / AdBlue Dosing Module

    0444023011

    Bosch part number

Get help to fix this fault by requesting a quote

Browse other Massey Ferguson codes