004363.10

Massey Ferguson 004363.10 – ECM: DOC Outlet Temp Sensor Abnormal Change

Issue description

The Engine Control Module (ECM) has detected an abnormal change rate in the signal from the Diesel Oxidation Catalyst (DOC) outlet temperature sensor. This sensor measures the exhaust gas temperature after it passes through the DOC, which is critical for monitoring DOC efficiency and controlling the diesel particulate filter (DPF) regeneration process. An implausible signal change usually indicates a sensor failure or a wiring connection issue.

Applies to these machines

  • 5710SL
  • 5711SL
  • 5712SL
  • 5713SL
  • 7614
  • 7615
  • 7616
  • 7618
  • 7619
  • 7620
  • 7622
  • 7624
  • 7626

Check the cause

  1. Turn the ignition and engine completely off.

  2. Locate the DOC outlet temperature sensor on the exhaust pipe between the DOC and the next after-treatment component.

  3. Inspect the sensor's electrical connector and harness for corrosion, bent or spread pins, dirt, moisture intrusion, rodent damage, chafing, or heat damage.

  4. Disconnect the sensor and measure resistance between the pins on the sensor side to check for an open circuit (infinite resistance) or short circuit (near-zero resistance).

  5. Measure resistance between the harness-side connector and the corresponding pins at the Aftertreatment Control Module (ACM) 120-pin connector to check for continuity or shorts to ground (e.g., a reading of less than 1K ohms could indicate a short).

Repair steps

  1. Repair wiring and connections

    If corrosion or damage is found, clean the connector pins or repair the damaged section of the harness. Ensure the connection is clean, dry, and secure. Sometimes simply disconnecting and reconnecting the sensor resolves a poor connection.

  2. Clear codes and test

    After performing wiring repairs, clear the fault codes using a diagnostic tool and operate the machine to see if the code returns.

  3. Replace DOC outlet temperature sensor

    If the wiring is in good condition and the fault persists, the sensor is likely faulty. Allow the exhaust system to cool completely, apply penetrating oil to the threads, and unscrew the old sensor. Install the new sensor and tighten to the manufacturer's specified torque. Do not over-tighten.

  4. Verify repair

    Connect the electrical harness to the new sensor, clear the fault codes, and run the tractor to verify the repair.

Parts you might need

(5)
  • DOC Outlet Temperature Sensor

    Specific OEM part number depends on engine and model year. Verify with an authorized AGCO dealer using the tractor's serial number.

  • General reference part number only; unverified for this specific application. Must verify fitment.

  • Temperature Sensor

    3907313M1

    General reference part number only; unverified for this specific application. Must verify fitment.

  • General reference part number only; unverified for this specific application. Must verify fitment.

  • General reference part number only; unverified for this specific application. Must verify fitment.

Get help to fix this fault by requesting a quote

Browse other Massey Ferguson codes