51.04

Massey Ferguson 51.04 – Engine Control Unit (ECU): Air Throttle Valve Position Sensor Voltage Low

Issue description

The controller detects that the voltage signal returning from the Air Throttle Valve (also known as the Intake Throttle Valve or ITV) position sensor has dropped below the acceptable minimum range. This typically indicates a short circuit to ground, a failed sensor, or a wiring harness issue.

Applies to these machines

  • 4710
  • 7724S
  • 5712SL
  • 7722S
  • 7722
  • 5713SL
  • 7720S
  • 7716
  • 7718
  • T4
  • 7715
  • 5710SL
  • 7726
  • 4708
  • 7726S
  • 4707
  • 4709
  • 5711SL
  • 7718S
  • 7719
  • 7714
  • 7716S
  • T4 (2015-2021)
  • 7720
  • Tier 4 (2015-2021)
  • 7715S
  • 7724
  • 5608
  • 5609
  • 5610
  • 5611
  • 5612
  • 5613
  • 5710 SL
  • 5711 SL
  • 5712 SL
  • 5713 SL
  • 7614
  • 7615
  • 7616
  • 7618
  • 7619
  • 7620
  • 7622
  • 7624
  • 7626

Check the cause

  1. Inspect the Air Throttle Valve wiring harness for chafing, bare wires, or a short circuit to ground.

  2. Check the Intake Throttle Valve (ITV) connector for corrosion, moisture, or backed-out pins.

  3. Consider environmental factors, as extreme cold temperatures can cause the valve to stick or falsely trigger throttle position codes.

  4. Test the voltage at the sensor to confirm if the sensor itself has failed internally or if the ECU is not supplying the correct reference voltage.

Repair steps

  1. Disconnect battery

    Disconnect the tractor's battery to prevent electrical spikes.

  2. Repair wiring harness

    If the diagnostic checks reveal a short to ground in the wiring harness, repair or replace the damaged section of the harness.

  3. Replace Air Throttle Valve

    If the wiring and connector are in good condition, the fault lies within the Air Throttle Valve position sensor. Because the sensor is typically integrated into the actuator assembly, the entire Air Throttle Valve must be replaced.

  4. Install new valve

    Install the new Air Throttle Valve and reconnect the harness.

  5. Finalize repair

    Reconnect the battery, clear the ECU fault codes using a diagnostic tool, and perform any required auto-calibration/learning procedures for the new throttle valve.

Parts you might need

(1)
  • Air Throttle Valve

    Also referred to as the Intake Throttle Valve, ITV, or Air Throttle Actuator. Source directly through an AGCO parts catalog using the specific tractor's serial number and engine configuration.

Get help to fix this fault by requesting a quote

Browse other Massey Ferguson codes