Massey Ferguson 6.01.1E – HITCH: Issue With PTO Circuit (Hitch)

Electrical malfunction, open circuit, or short within the Power Take-Off (PTO) control circuit, preventing the system from properly sending or receiving signals to engage/disengage the PTO clutch.

• 5710SL
• 5711SL
• 5712SL
• 5713SL
• T4
• 4707
• 4708
• 4709
• 4710
• 5608
• 5609
• 5610
• 5611
• 5612
• 5613
• 7614
• 7615
• 7616
• 7618
• 7619
• 7620
• 7622
• 7624
• 7626
• 7714
• 7715
• 7715S
• 7716
• 7716S
• 7718
• 7718S
• 7719
• 7720
• 7720S
• 7722
• 7722S
• 7724
• 7724S
• 7726
• 7726S

1. 1

   Verify battery and charging system for stable voltage, as low voltage can cause the HITCH module to throw false circuit codes.

2. 2

   Check the yellow PTO rocker switch in the cab for continuity to ensure it isn't suffering from mechanical or electrical failure.

3. 3

   Inspect safety interlocks, including the seat safety switch and neutral interlock switches, which can interrupt the PTO circuit.

4. 4

   Test the PTO solenoid coil: check the wiring harness for chafing or corrosion, apply 12V to check for magnetism, and test for an open circuit with a multimeter.

5. 5

   Check hydraulic fluid levels and ensure filters are clean, as the electrical solenoid opens a valve to allow hydraulic pressure to engage the clutch.

1. 1

   Power Down

   Turn off the tractor, remove the key, and allow the hydraulic system to depressurize.

2. 2

   Locate the Valve

   Find the PTO pressure regulator and solenoid valve block on the rear transmission housing.

3. 3

   Disconnect Wiring

   Unplug the electrical connector from the faulty PTO solenoid. Inspect the harness connector for dirt or corrosion and clean if necessary.

4. 4

   Remove the Coil

   Remove the retaining nut or clip holding the solenoid coil to the valve stem. Slide the old coil off.

5. 5

   Install New Part

   Slide the new solenoid coil onto the stem, secure the retaining nut, and plug in the wiring harness.

6. 6

   Clear Codes

   Use a compatible diagnostic tool to clear the 06.01.1E code from the HITCH module.

7. 7

   Test

   Start the tractor and engage the PTO switch to verify proper operation.