Massey Ferguson 8.X.18 – HITCH: Rear Hitch Raise/Lower Rocker Switch Signal Issue

The controller is receiving an incorrect signal from component X119, which is the main rear linkage lifting/lowering switch located in the cab. This means the switch is sending an out-of-range, missing, or implausible electrical signal when the operator attempts to raise or lower the 3-point hitch.

• 5710SL
• 5711SL
• 5712SL
• 5713SL
• T4
• 5400 Series
• 6400 Series
• 5600 Series
• 5608
• 5609
• 5610
• 5611
• 5612
• 5613
• 5700 Series
• 5710 SL
• 5711 SL
• 5712 SL
• 5713 SL
• 6600 Series
• 6700 Series
• 7400 Series
• 7600 Series
• 7700 Series
• 7714
• 7715
• 7716
• 7718
• 8600 Series

1. 1

   Verify system voltage is between 11 V and 16 V, as voltage outside this range will cause the Autotronic controller to log linkage errors.

2. 2

   Inspect the wiring harness and the multi-pin connector at the X119 cab rocker switch for open circuits, short circuits to +12V, short circuits to earth, or corrosion.

3. 3

   Check the external fender-mounted linkage switches (X87 on the right-hand fender and X97 on the left-hand fender) for water ingress or shorts, which can send conflicting signals mimicking a main switch failure.

1. 1

   Turn off the tractor ignition and disconnect the battery

   This protects the Autotronic controller.

2. 2

   Locate the X119 rear linkage rocker switch

   Find the switch on the side console or armrest.

3. 3

   Remove the faulty switch

   Carefully unclip and remove the faulty switch from the console panel.

4. 4

   Disconnect the electrical harness

   Disconnect the harness from the back of the switch, ensuring the connector pins are clean.

5. 5

   Install the new switch

   Plug the wiring harness into the new OEM rocker switch and snap it back into the console.

6. 6

   Reconnect the battery and turn on the ignition

7. 7

   Clear stored error codes

   Clear the stored error codes from the tractor's diagnostic display memory.

8. 8

   Test the hitch operation

   Confirm the signal issue is resolved. Note: Depending on the tractor series, a hitch calibration sequence may be required after replacing linkage control components.