9031

Massey Ferguson 9031 – ECU: Short Circuit to EARTH in ECU Main Relay 2

Issue description

The Engine Control Unit (ECU) has detected a short circuit to ground in the control or power circuit of its second main relay. This relay is critical for providing power to the ECU, which manages essential engine functions. An unintended connection to the chassis ground prevents the relay from energizing, leading to a loss of power to the ECU and resulting in a no-start condition or intermittent engine shutdown.

Applies to these machines

  • 3000 Series
  • 5400 Series
  • 5600 Series
  • 6400 Series
  • 6600 Series
  • 7400 Series
  • 7600 Series
  • 8600 Series

Check the cause

  1. Record the exact fault code, including the FMI number (e.g., E 9031 6), and any other active codes

  2. Check the battery and charging system to ensure the battery is fully charged (around 12.6V) and the alternator provides stable voltage (13.5-14.5V)

  3. Thoroughly inspect the wiring harness leading to the ECU and the main relay box for signs of damage, chafing, melting, or corrosion

Repair steps

  1. Disconnect Power

    Disconnect the battery ground cable before performing any electrical repairs to ensure safety.

  2. Locate "ECU Main Relay 2"

    Consult the tractor's service manual or wiring diagram to find the relay in the main fuse and relay box, typically located in the engine bay or near the ECU.

  3. Test the Relay

    Swap the ECU Main Relay 2 with an identical, known-good relay from a non-critical circuit (e.g., horn or work lights). Clear fault codes and attempt to start the engine. If the fault clears, replace the original relay.

  4. Test the Relay Circuit

    If the fault persists, remove the relay and use a multimeter to check for continuity between the relay's control-side pin and chassis ground, and the power-side pin and chassis ground. There should be no continuity.

  5. Isolate the Short

    If a short to ground is detected, inspect the wiring harness between the fuse box and the ECU. If the wiring is intact, the ECU itself may require professional testing, repair, or replacement.

  6. Final Verification

    Reconnect the battery, clear all fault codes, and operate the tractor to ensure the repair was successful and the code does not return.

Parts you might need

(5)
  • Compatible with 5600, 6400, 6600, 7400, 7600, and 8600 series. Confirm with serial number.

  • Alternative relay part number.

  • 5-Pin Relay

    7066359M91

    Alternative relay part number.

  • 12V 5-Pin Main Relay / Multi-Function Relay

    4349213M1

    12V Relay for Massey Ferguson/Valtra. Always verify the amperage and pin layout of the pulled relay against the replacement.

  • Relay Board Module

    6102205M91

    Some boards use a complete module like this reference.

Get help to fix this fault by requesting a quote

Browse other Massey Ferguson codes