Massey Ferguson A.11.19 – Mid Mount Valve Module / Auxiliary Valve Controller: External Hydraulic Valve 1 Issue

Malfunction in the circuit or operation of the first external hydraulic remote valve (spool valve), typically an electrical fault such as a connection problem or an issue with the spool position sensor value.

• 5710SL
• 5711SL
• 5712SL
• 5713SL
• T4
• 5608
• 5609
• 5610
• 5611
• 5612
• 5613
• 7614
• 7615
• 7616
• 7618
• 7619
• 7620
• 7622
• 7624
• 7626
• 7714
• 7715
• 7715S
• 7716
• 7716S
• 7718
• 7718S
• 7719
• 7720
• 7720S
• 7722
• 7722S
• 7724
• 7724S
• 7726
• 7726S

1. 1

   Check the wiring harness and connectors leading to External Hydraulic Valve 1 for corrosion, bent pins, or connection problems

2. 2

   Check the spool position sensor output using a compatible diagnostic tool to verify if the value is erratic or missing

3. 3

   Verify communication between the Dash and the Mid Mount Valve Module on the CAN Bus

1. 1

   Clear the code

   Clear the code using a compatible diagnostic tool to see if it is an active or stored fault.

2. 2

   Clean the electrical connector

   Disconnect and clean the electrical connector at the #1 external spool valve.

3. 3

   Replace and calibrate the electric spool slice

   If the wiring is intact but the spool position sensor value remains out of range, the electric spool slice (or its pilot pressure control solenoid) must be replaced and subsequently reprogrammed/calibrated to the tractor.