A.30.27

Massey Ferguson A.30.27: External Hydraulic Valve 3 Issue

Issue description

Indicates a fault within the third external hydraulic remote valve circuit, likely an electrical circuit or solenoid connection failure.

Use a diagnostic tool or interface device compatible with Massey Ferguson tractors to pull the active DTCs and confirm the presence of 0A.30.27.
Locate External Hydraulic Valve 3 (typically at the rear remote stack) and visually inspect the electrical connections for problems.
Check the wiring harness leading to the valve for chafing, breaks, or corrosion that could interrupt the signal from the onboard diagnostic system.

Ensure the tractor is turned off and hydraulic pressure is relieved.
Disconnect the electrical harness connector at External Hydraulic Valve 3.
Clean the connector pins and ensure they are seated tightly. If the connector or wiring is damaged, repair or replace the pigtail/harness.
If the wiring is intact and the connection is secure, the valve's electronic solenoid or the valve assembly itself has likely failed and must be replaced.
After replacing the faulty component, reconnect the diagnostic tool to clear the DTCs.
Test the operation of the #3 hydraulic remote to ensure the code does not return.

(1)

External Hydraulic Valve Assembly / Hydraulic Spool Valve (Remote #3)
Consult a Massey Ferguson AGCO parts catalog with the specific tractor's serial number to get the exact electronic spool valve replacement.

Get help to fix this fault by requesting a quote