A.6X.23

Massey Ferguson A.6X.23 – Chassis/Hydraulic Controller or Transmission ECU: External Hydraulic Valve 6 Issue

Issue description

Malfunction, electrical fault, or mechanical sticking within the 6th rear remote/auxiliary hydraulic spool valve circuit.

Inspect electrical connections and wiring harness leading to External Hydraulic Valve 6 for corrosion, bent pins, or frayed wires
Test the solenoid on Valve 6 for proper resistance and verify it receives voltage when commanded from the cab
Check for mechanical binding to see if the spool is physically sticking in one direction
Inspect the valve block for external hydraulic fluid leaks indicating failed O-rings or seals

Relieve Pressure
Turn off the tractor and cycle the hydraulic remote levers/switches to relieve all residual hydraulic pressure in the system.
Disconnect
Disconnect the electrical harness connectors to the Valve 6 solenoid.
Remove Lines
Mark and disconnect the hydraulic hoses/lines attached to the 6th remote valve section. Cap the lines to prevent contamination.
Dismount Valve
Unbolt the Valve 6 section from the external hydraulic valve stack/block.
Rebuild or Replace
If the valve is leaking or sticking due to degraded seals, disassemble the spool and install a spool valve repair kit (replacing all O-rings and seals). If the internal spool is heavily scored or the solenoid has failed internally, the entire valve section must be replaced.
Reinstall
Bolt the valve back into the stack, reconnect the hydraulic lines, and plug in the electrical connector.
Test
Start the tractor, operate the valve to bleed any trapped air, and check for leaks and proper operation. Clear the DTC using a compatible diagnostic tool.

(2)

OEM Spool Valve Repair Kit
3176423M91
Massey Ferguson OEM Kit, Repair - used for restoring hydraulic functionality to leaking/sticking tractor spool valves
3176423M91

External Hydraulic Valve Assembly or Hydraulic Remote Valve Kit
Specific to your tractor's exact configuration (e.g., single/double acting, electro-hydraulic proportional valve). Required if the entire valve needs replacement.

Get help to fix this fault by requesting a quote