A.81.22

Massey Ferguson A.81.22: External Hydraulic Valve 8 Issue

Issue description

The tractor's onboard diagnostic system has detected a malfunction, electrical short, or connection problem specifically on the 8th external hydraulic remote/spool valve.

Applies to these machines

  • 5710SL
  • 5711SL
  • 5712SL
  • 5713SL
  • T4
  • 4707
  • 4708
  • 4709
  • 4710
  • 5608
  • 5609
  • 5610
  • 5611
  • 5612
  • 5613
  • 7614
  • 7615
  • 7616
  • 7618
  • 7619
  • 7620
  • 7622
  • 7624
  • 7626
  • 7714
  • 7715
  • 7715S
  • 7716
  • 7716S
  • 7718
  • 7718S
  • 7719
  • 7720
  • 7720S
  • 7722
  • 7722S
  • 7724
  • 7724S
  • 7726
  • 7726S

Check the cause

  1. Inspect the wiring harness and electrical connections on External Valve 8 for frayed wires, corrosion, or loose pins

  2. Test the voltage reaching the valve's solenoid and verify the resistance of the solenoid coil against OEM specifications

  3. Check the hydraulic fluid level and ensure the filter is not bypassed or clogged, which can cause flow or pressure issues at the remotes

Repair steps

  1. Power Down and Relieve Pressure

    Turn off the tractor and actuate the hydraulic levers/buttons to relieve any residual pressure in the hydraulic system.

  2. Clean and Re-seat Connectors

    Disconnect the electrical harness to Valve 8. Clean the contacts with electronic contact cleaner, apply dielectric grease, and re-seat the connector. Clear the code with a diagnostic tool to see if the fault returns.

  3. Remove the Faulty Valve

    If the electrical connection is sound but the valve is internally failed, unbolt the hydraulic lines connected to Valve 8.

  4. Replace the Spool Valve

    Remove the mounting bolts securing the spool valve to the hydraulic block. Install the new spool valve assembly, ensuring all O-rings and seals are new and properly seated to prevent leaks.

  5. Reassembly

    Torque the mounting bolts to spec, reconnect the hydraulic lines, and plug in the electrical harness.

  6. Final Testing

    Top off the hydraulic fluid if any was lost. Start the tractor, actuate the valve to bleed any air, and use a compatible diagnostic tool to clear the A.81.22 code.

Parts you might need

(5)
  • Rexroth Hydraulic Electric Spool Valve (4-PIN)

    3797234M6

    Direct OEM replacement for the electronic spool valves used on the 7600 series (as well as 6400, 6600, and 7400 series).

  • Hydraulic Spool Valve Assembly

    1696239M93

    Common mechanical/standard spool valve for older or lower-spec Massey Ferguson models.

  • Hydraulic Spool Valve Assembly

    1696239M92

    Common mechanical/standard spool valve for older or lower-spec Massey Ferguson models.

  • Hydraulic Auxiliary Spool Valve

    3108256M1

    With load sensing.

  • Hydraulic Auxiliary Spool Valve

    3796083M3

    With load sensing.

Get help to fix this fault by requesting a quote

Browse other Massey Ferguson codes