AR05

Massey Ferguson AR05 – TECU: CAN Message (Small Armrest) Fault

Issue description

The system has detected a loss of communication or an invalid message from the control module located in the small armrest over the CAN bus. This indicates a communication problem within the armrest system pathway or the armrest controller itself, rather than a specific mechanical component failure.

Applies to these machines

  • 7614
  • 7615
  • 7616
  • 7618

Check the cause

  1. Record the exact fault code and check for other codes (multiple CAN codes indicate a network problem, while a single AR05 points specifically to the armrest circuit)

  2. Inspect the fuse box for any blown fuses related to the armrest controls or the TECU

  3. Verify the armrest control module is receiving correct voltage and has a solid ground connection

  4. Visually inspect the wiring harness running to and from the armrest for chafing, pinching, or cuts, especially near moving parts or the cab floor

  5. Unplug and inspect connectors at the armrest module and TECU for corrosion, bent pins, moisture intrusion, and secure seating

  6. With the battery disconnected, measure CAN bus resistance across CAN High and CAN Low wires (should be approximately 60 ohms; 120 ohms indicates a break/missing resistor, near 0 ohms indicates a short)

Repair steps

  1. Address power issues

    Check the battery and charging system to rule out low voltage as a cause before proceeding with CAN diagnostics.

  2. Clean and secure connectors

    Disconnect the main electrical connector for the armrest. Clean the pins and sockets with electrical contact cleaner and ensure a secure connection upon reassembly.

  3. Test wiring harness continuity

    Perform a continuity test on the power, ground, and CAN bus wires between the armrest controller and the Autotronic 5 TECU to identify any open circuits or shorts.

  4. Isolate the module

    If wiring is good, swap the armrest control module with a known-good module from an identical tractor to confirm if the original module is the source of the fault.

  5. Replace and program module

    If the armrest control module is faulty, replace it. Note that some replacement modules may require programming by a certified dealer to function correctly.

Parts you might need

(3)
  • Fits 5600, 5700, 6600, 6700, 7600, and 7700 series.

  • Complete Armrest Assembly

    3904442M91

    Fits 4200 to 8400 series. Confirm fitment for specific model.

  • Wiring Harness

    3614413M91

    Example part number; verify correct harness using tractor serial number.

Get help to fix this fault by requesting a quote

Browse other Massey Ferguson codes