AR22

Massey Ferguson AR22 – Armrest: Short Circuit to 12 V

Issue description

A component's electrical circuit has a short to the 12-volt power supply. Specifically, a wire for the 'FingerTIP 2' control on the armrest that should be carrying a signal or be grounded has improperly come into contact with a 12-volt power source. This can lead to unpredictable behavior in the affected system.

Applies to these machines

  • 8600 Series

Check the cause

  1. Visually inspect the wiring harness associated with the armrest controls, particularly for the 'FingerTIP 2' button, looking for signs of chafing, pinching, or damage.

  2. Using a multimeter, test the signal wire of the 'FingerTIP 2' control. With the key on, the presence of a constant 12 volts (when the button is not actively pressed) confirms a short circuit condition.

  3. Disconnect and inspect the electrical connectors for the armrest controls for corrosion, pushed-out pins, or any debris that could be causing a short.

Repair steps

  1. Isolate the fault

    Disconnect the 'FingerTIP 2' switch from the circuit. If the AR22 code disappears, the switch itself is likely faulty and internally shorted.

  2. Trace the wiring

    If the code remains with the switch disconnected, the fault lies within the wiring harness. Trace the wire from the armrest controller to the 'FingerTIP 2' switch to locate the point of contact with a 12-volt power wire.

  3. Repair the wiring

    Once the location of the short is found, separate the wires and repair the damaged insulation using high-quality electrical tape or heat-shrink tubing. Secure the harness away from any sharp edges or moving parts to prevent future damage.

  4. Replace component

    If the 'FingerTIP 2' switch was determined to be internally shorted in step 1, replace the switch with a new OEM component.

  5. Clear codes and test

    After the repair is complete, clear the fault codes using a diagnostic tool or through the tractor's dashboard interface. Operate the 'FingerTIP 2' control to ensure it is functioning correctly and that the AR22 code does not reappear.

Parts you might need

(1)
  • FingerTIP 2 switch (Component X308)

    OEM Massey Ferguson/AGCO part. Verify exact part number using AGCO Parts Books online catalog for your specific 8600 series model.

Get help to fix this fault by requesting a quote

Browse other Massey Ferguson codes