AR39

Massey Ferguson AR39 – Armrest / Armrest Autotronic 5: Armrest FingerTIP 3 Calibration Incomplete

Issue description

The fault code indicates that the calibration for the armrest's 'FingerTIP 3' control lever has not been successfully completed or the stored calibration data is incorrect. Because the electronic control module lacks the precise operating parameters and position sensor end-points for the lever, the associated hydraulic implements or spool valves may operate improperly or become non-functional.

Applies to these machines

  • MF 5700 SL Series
  • MF 7600 Series (including Dyna-4, Dyna-6, and Dyna-VT transmissions)
  • MF 8600 Series

Check the cause

  1. Verify that the AR39 code is active and note any corresponding issues with hydraulic functions.

  2. Check for other active fault codes related to the armrest, power supply, or CAN communication (such as AR31 or AR32 indicating short circuits or voltage issues with FingerTIP 3), as these must be addressed before calibration.

  3. Visually inspect the wiring harness for the armrest controls, looking for any signs of damage, chafing, or loose connections.

Repair steps

  1. Connect diagnostic tool

    Connect a specialized dealer diagnostic tool to the tractor, as this calibration cannot be performed through the standard instrument panel.

  2. Navigate to calibration menu

    Within the diagnostic software, select the calibration routine for the armrest FingerTIP controls.

  3. Perform calibration

    Follow the on-screen instructions. This typically involves moving the FingerTIP 3 lever to its full extent of motion to allow the controller to learn the end-points of its position sensor.

  4. Verify calibration status

    The diagnostic tool will indicate whether the calibration was successful ('Cal OK') or if an error occurred ('Cal ERR'). If an error occurs, re-check pre-conditions (such as oil temperature, engine speed, etc.) and component integrity before attempting calibration again.

  5. Clear faults and test

    Once calibration is complete, clear the AR39 fault code and verify that it does not return. Test the function of the FingerTIP 3 control to ensure proper operation. If calibration repeatedly fails, it indicates a fault with the FingerTIP 3 position sensor itself or the armrest control unit.

Parts you might need

(4)
  • Massey Ferguson Armrest

    3904442M91

    OEM part noted for 4200-8400 Series. Verify fitment by serial number.

  • OEM part. Verify fitment by serial number.

  • Used part. Verify fitment by serial number.

  • Massey Ferguson Armrest Control Unit

    24183-Earml

    Noted for 8240. Verify fitment by serial number.

Get help to fix this fault by requesting a quote

Browse other Massey Ferguson codes