AR49

Massey Ferguson AR49 – ACM: Armrest FingerTIP 4 Calibration Error

Issue description

The Armrest Control Module (ACM) has detected that the calibration for the 'FingerTIP 4' control has not been completed, or the stored calibration values are incorrect or out of range. The sensor data associated with this fingertip control is illogical or outside expected parameters, preventing the armrest system from operating correctly as a safety precaution.

Applies to these machines

  • MF 5600
  • MF 5700
  • MF 6600
  • MF 6700
  • MF 7600
  • MF 7700
  • MF 8600

Check the cause

  1. Scan for any other active fault codes, particularly those related to voltage supply or other sensor failures that can interfere with calibration

  2. Inspect the wiring harness and connector to the 'FingerTIP 4' lever for damage, corrosion, or loose connections

  3. Verify the tractor's electrical system voltage is stable, as low battery voltage or charging system problems can lead to calibration errors

  4. Check the 'FingerTIP 4' lever for mechanical issues, ensuring it is not stuck, binding, or restricted by debris

Repair steps

  1. Access calibration menu

    Access the calibration menu through the tractor's main display (Dash Control Center) by pressing and holding the specific combination of buttons for your model.

  2. Select correct calibration

    Navigate through the menus to the armrest or hydraulic lever calibration section and select 'FingerTIP 4' or the general armrest lever calibration.

  3. Perform lever calibration

    Follow the on-screen prompts to move the 'FingerTIP 4' lever to its full extent in each direction (fully forward, fully back) and return it to the neutral position so the system can record the sensor voltage signals.

  4. Save calibration

    Save the new calibration values. On some models, this requires turning the ignition off for a set period to store the values in the controller's memory.

  5. Contact an authorized dealer

    If the calibration repeatedly fails or the AR49 code immediately returns, it indicates a deeper issue such as a faulty sensor within the fingertip lever, a problem with the Armrest Control Module, or a wiring fault. In such cases, contacting a dealer is necessary.

Parts you might need

(4)
  • Example part number; always verify with a dealer using the tractor's serial number

  • Armrest Assembly

    3904442M91

    Example part number; required if individual components are not sold separately

  • For joystick elements on the control armrest

  • Fingertip Lever Assembly

    The sensor is typically integrated into the lever assembly

Get help to fix this fault by requesting a quote

Browse other Massey Ferguson codes