AR61

Massey Ferguson AR61 – Armrest: Finger TIP 6 Front Linkage Short Circuit

Issue description

The electrical circuit associated with the 'Finger TIP 6' control for the front linkage has an abnormally low voltage, indicating a short circuit to ground (0 V). This direct or near-direct connection to the ground side of the electrical system prevents the component from sending a valid signal to the armrest control unit.

Applies to these machines

  • 5S
  • 6S
  • 7S
  • 8S
  • 5700
  • 6700
  • 7700
  • 8700
  • 5700 S
  • 6600
  • 7600
  • 6700 S
  • 7700 S
  • 4200
  • 8400

Check the cause

  1. Visually inspect the wiring harness leading to and around the armrest controls, specifically the front linkage controls, for chafing, pinching, or heat damage.

  2. Disconnect and inspect the electrical connectors for the Finger TIP 6 control and the main armrest control module for corrosion, moisture ingress, or pushed-out pins.

  3. Perform a continuity test to ground on the signal wire for the X130 Finger TIP 6 function with the component and control module disconnected (a reading near 0 ohms confirms a short to ground).

  4. Perform a voltage drop test on the ground circuit to identify any poor ground connections.

Repair steps

  1. Isolate the fault

    Disconnect the Finger TIP 6 component. If the fault code disappears, the component itself is likely internally shorted. If the fault remains, the issue is in the wiring harness between the component and the control module.

  2. Repair wiring harness

    If the short circuit is located in the wiring harness, identify the damaged section. Splice in a new section of the correct gauge wire using sealed connectors or solder and heat shrink tubing. If damage is extensive, replace the armrest wiring harness.

  3. Replace component

    If the Finger TIP 6 control is determined to be internally shorted, replace the individual switch, joystick, or control panel assembly.

  4. Replace control module

    If the wiring and component are in good condition and the fault persists, replace the armrest control module as a last resort.

  5. Clear Fault Codes

    After completing the repair, reconnect all components and use a diagnostic tool to clear the AR61 fault code.

  6. Verify Repair

    Operate the front linkage using the 'Finger TIP 6' control to ensure that the fault does not return and the function is restored.

Parts you might need

(4)
  • Associated with armrest controllers for 5700 S, 6600, 7600, 6700 S, and 7700 S series

  • Armrest Assembly

    3904442M91

    Listed as an armrest for the 4200-8400 series

  • May contain the Finger TIP 6 control switch

  • Front Linkage Fingertip Control Switch/Joystick

    Generic part name; component is likely part of a larger assembly

Get help to fix this fault by requesting a quote

Browse other Massey Ferguson codes