AR72

Massey Ferguson AR72 – Armrest: Hand Throttle Short to 12V

Issue description

The Armrest control module has detected an abnormally high voltage in the electrical circuit for the hand throttle (component X122). The signal wire from the hand throttle sensor is improperly receiving full battery voltage due to a short circuit to the 12-volt power supply.

Applies to these machines

  • 8600 Series
  • 8650
  • 8660
  • 8670
  • 8680
  • 8690
  • 8700 Series

Check the cause

  1. Visually inspect the wiring harness leading to and from the hand throttle (X122) on the armrest for chafed, pinched, or melted insulation.

  2. Disconnect the hand throttle sensor connector and inspect pins and terminals for corrosion, moisture, or damage. Clean with electrical contact cleaner if necessary.

  3. With the key on, probe the hand throttle connector to verify correct supply voltage and a good ground connection.

  4. With the sensor disconnected and key on, measure voltage on the signal wire in the harness-side connector. If 12 volts are present, the harness is shorted to a power source.

  5. If the harness is shorted, carefully remove the protective loom to trace the signal wire and identify where it is contacting a 12V power wire.

  6. If the harness wiring tests good, the hand throttle sensor itself likely has an internal short circuit.

Repair steps

  1. Disconnect battery

    Disconnect the tractor's battery before beginning any repair work on the electrical system to prevent accidental shorts.

  2. Access hand throttle

    Remove necessary panels or covers to gain access to the hand throttle assembly (X122) and its wiring within the armrest console.

  3. Perform Diagnostics

    Follow the diagnostic checks outlined above to confirm whether the fault is in the wiring harness or the hand throttle sensor itself.

  4. Repair wiring harness

    If a short is found in the harness, carefully repair the damaged section using appropriate connectors and heat shrink tubing to ensure a durable and insulated connection. Re-secure the harness away from any sharp edges or pinch points.

  5. Replace hand throttle sensor

    If the hand throttle sensor (X122) is determined to be faulty, it must be replaced.

  6. Reassemble and test

    Reconnect the battery, turn the ignition on, and clear any stored fault codes using an appropriate diagnostic tool if available. Operate the hand throttle and check for the return of the AR72 fault code.

Parts you might need

(1)
  • AGCO OEM part. Fits multiple series including 8600 and 8700. Verify with specific tractor serial number before ordering.

Get help to fix this fault by requesting a quote

Browse other Massey Ferguson codes