E 100 (2)

Massey Ferguson E 100 (2) – Engine Control Unit (ECU) / AGCO SISU POWER Electronic Engine Management system (EEM3 or EEM4): Oil pressure NO SIGNAL / Oil pressure sensor not plausible

Issue description

The Engine Control Unit (ECU) is not receiving a signal from the engine oil pressure sensor. This indicates an electrical failure, such as an open circuit in the wiring, a disconnected sensor, or a completely failed sensor component, rather than a mechanical lubrication issue. The ECU relies on a continuous signal from this sensor to monitor the engine's lubrication system.

Applies to these machines

  • 3600
  • 4600
  • 5400
  • 5600
  • 6400
  • 6600
  • 7400
  • 7600
  • 7700
  • 8400
  • 8600
  • 8700
  • 9695
  • 9795

Check the cause

  1. Check the engine oil level manually using the dipstick to ensure the engine has the correct amount of oil

  2. Inspect the electrical connector at the oil pressure sensor and the wiring harness leading back to the Engine ECU for open circuits, short circuits to ground/positive, or damaged pins

  3. Verify mechanical oil pressure by connecting a mechanical engine oil pressure test gauge (e.g., Caterpillar tool 1U-5470 or equivalent) to the engine block to rule out internal engine failure or a bad oil pump

Repair steps

  1. Turn off the engine and disconnect the battery

    Turn off the engine, remove the key, and disconnect the battery to prevent electrical shorts.

  2. Locate the engine oil pressure sensor

    On Sisu engines, it is typically threaded into the lower cylinder block near the main oil gallery or oil filter housing.

  3. Disconnect the electrical wiring harness

    Depress the locking tab and disconnect the electrical wiring harness from the sensor.

  4. Remove the faulty oil pressure sensor

    Using a wrench, carefully unscrew the faulty oil pressure sensor from the engine block. Have a shop rag ready to catch any residual oil that may drip out.

  5. Install the new oil pressure sensor

    Thread the new OEM oil pressure sensor into the port by hand to prevent cross-threading, then tighten it to the manufacturer's specified torque.

  6. Reconnect the electrical wiring harness

    Reconnect the electrical wiring harness until it clicks securely into place.

  7. Test the repair

    Reconnect the battery, start the engine, and monitor the instrument panel. Ensure the E 100 (2) fault code clears and verify there are no oil leaks around the new sensor.

Parts you might need

(7)
  • Engine Oil Pressure Sensor / Switch

    4358648M1
  • Oil Pressure Sensor

    QTP-600184

    Aftermarket sensor compatible with 5400, 5600, 6600, 7600, 8600, and 8700 series

  • Engine Oil Pressure Switch

    1877721M92

    OEM engine oil pressure switch

  • Hydraulic Oil Pressure Switch

    3595186M2

    Listed for reference but likely not the cause of an engine oil pressure fault

Get help to fix this fault by requesting a quote

Browse other Massey Ferguson codes