E 174 (3)

Massey Ferguson E 174 (3) – Engine ECU (Electronic Engine Management / EEM): HIGH fuel temperature sensor fault

Issue description

Fuel temperature sensor voltage above normal or open circuit. The engine control unit is receiving a voltage signal from the fuel temperature sensor that exceeds the normal operating parameters, which is almost always caused by a broken wire, a disconnected plug, or an internally failed sensor.

Applies to these machines

  • 8600 Series
  • 7600 Series
  • 7700 and 7700S Series
  • 5700SL Series
  • Various Dyna-4 and Dyna-6 transmission models
  • 4700 Series
  • 5400 Series
  • 5600 Series
  • 5700 Series
  • 6400 Series
  • 6600 Series
  • 6700 Series
  • 7400 Series
  • 8400 Series
  • 8700 Series

Check the cause

  1. Check the fuel temperature sensor connector for loose, corroded, or backed-out pins.

  2. Trace the wiring harness from the fuel temperature sensor back to the Engine ECU. Look for chafed wires, breaks, or areas where the wire might be shorting to a power source.

  3. Use a multimeter to check the internal resistance of the fuel temperature sensor. An infinite reading (OL) confirms the sensor has an internal open circuit and must be replaced.

Repair steps

  1. Turn off the tractor ignition and disconnect the battery to protect the Engine ECU.

  2. Locate the fuel temperature sensor on the engine's fuel system.

  3. Disconnect the electrical harness connector from the sensor.

  4. If the diagnostic checks revealed a broken wire in the harness, repair the open circuit.

  5. If the sensor itself is faulty, unscrew the old fuel temperature sensor.

    Have a shop rag ready to catch minor fuel drips.

  6. Install the new OEM fuel temperature sensor.

    Thread size M14x1.5.

  7. Reconnect the electrical harness to the new sensor.

  8. Reconnect the battery, turn the ignition on, and use a diagnostic tool to clear the E 174 (3) fault code from the Engine ECU.

  9. Start the engine and verify that the code does not return.

Parts you might need

(5)

Get help to fix this fault by requesting a quote

Browse other Massey Ferguson codes