E 9133 (3)

Massey Ferguson E 9133 (3) – Engine ECU (Sisu Engine Electronic Management (EEM3) module): Solenoid valve 3, short circuit between cables (bank off)

Issue description

The Engine Control Unit (ECU) has detected a short circuit in the electrical circuit for the injector solenoid designated as valve 3. This indicates that the wires leading to or from the solenoid are likely touching each other, or the low-side driver wire is shorted to a positive voltage source. To prevent damage to the engine and fuel system, the ECU shuts down the affected bank of injector drivers ('bank off'), activates a warning lamp on the instrument panel, and significantly reduces engine power and speed.

Applies to these machines

  • 5460
  • 5465
  • 5470
  • 5475
  • 5480
  • 6460
  • 6465
  • 6470
  • 6475
  • 6480
  • 6485
  • 6490
  • 6495
  • 6497
  • 6499
  • 7465
  • 7475
  • 7480
  • 7485
  • 7490
  • 7495
  • 7497
  • 7499
  • 8450
  • 8460
  • 8470
  • 8480
  • 8650
  • 8660
  • 8670
  • 8680
  • 8690
  • 9795
  • Centora
  • Delta
  • Beta

Check the cause

  1. Visually inspect the engine wiring harness connecting the EEM3 Engine ECU to Injector 3 for visible chafing, melting, or bare wires.

  2. Disconnect the harness at Injector 3 and at the Engine ECU. Use a multimeter to check for continuity between the two wires dedicated to Injector 3. There should be no continuity (no short) between them.

  3. Check for a short to battery voltage (+) on the low side of the injector circuit.

  4. Measure the internal resistance of the Injector 3 solenoid to ensure the short is not internal to the injector itself.

  5. Inspect the ECU and injector connector pins for corrosion, moisture ingress, or pushed/bent pins.

Repair steps

  1. Turn off machine and disconnect battery

    Turn off the machine and disconnect the battery to prevent electrical damage during testing and repair.

  2. Locate Injector 3

    Locate Injector 3 on the engine cylinder head.

  3. Disconnect electrical connectors

    Disconnect the electrical connector from Injector 3 and the main connector at the Engine ECU.

  4. Perform continuity and resistance checks

    Perform the multimeter continuity and resistance checks on the harness as outlined in the diagnostic steps.

  5. Repair or replace wiring harness

    If the wiring harness is shorted, repair the damaged section of the wires or replace the engine wiring harness entirely.

  6. Replace fuel injector

    If the harness tests good but the injector solenoid is internally shorted, the fuel injector must be replaced: Clean the area around the injector to prevent debris from entering the cylinder. Remove the high-pressure injector pipe. Remove the injector hold-down clamp and extract the faulty injector. Install the new injector using a new copper sealing washer. Torque the hold-down clamp and install a new high-pressure fuel line to OEM specifications.

  7. Reconnect electrical connections

    Reconnect all electrical connections and the battery.

  8. Clear fault code

    Use a diagnostic service tool (such as WinEEM3s or Jaltest) to clear the E 9133 (3) fault code from the Engine ECU.

  9. Verify repair

    Prime the fuel system and run the engine to verify the repair and ensure there are no high-pressure fuel leaks.

Parts you might need

(10)

Get help to fix this fault by requesting a quote

Browse other Massey Ferguson codes