E 9135 (31)

Massey Ferguson E 9135 (31) – Engine Control Unit (ECU) / Sisu EEM3: Solenoid valve 5, fast decay error (bank off)

Issue description

The Engine Electronic Module (EEM3) has detected a fast decay error related to solenoid valve 5 when the bank is off. This indicates that the fuel injector solenoid for cylinder 5 is not closing as quickly as expected during the decay phase after an injection event. This malfunction can lead to the injector remaining open longer than intended, potentially causing an over-fueling condition in the affected cylinder. As a protective measure, the ECU may shut down the entire bank of injectors associated with solenoid 5 to prevent engine damage.

Applies to these machines

  • Massey Ferguson 8600 Series
  • MF 8650
  • MF 8660
  • MF 8670
  • MF 8680
  • MF 8690
  • Massey Ferguson 6600 Series
  • Massey Ferguson 7400 Series
  • Massey Ferguson 7600 Series
  • Massey Ferguson 8400 Series
  • Massey Ferguson 9000 Series

Check the cause

  1. Check ECU connectors to ensure the locking mechanisms are secure and the metallic locking lever is in its final position.

  2. Inspect the wiring harness leading to injector solenoid valve 5 for a short circuit to ground or a short circuit to the battery (+) from the solenoid valve's low side.

  3. Use the WinEEM3s Service Tool to run a high-pressure pump test to check for leakage, which could indicate an issue with the high-pressure pump or MPROP solenoid valve rather than the injector.

Repair steps

  1. Disconnect battery and clean area

    Disconnect the battery and clean the area around the affected injector (cylinder 2 on 6-cyl engines) to prevent debris from entering the engine.

  2. Remove fuel lines and connector tube

    Remove the high-pressure fuel lines and the connector tube leading to the injector.

  3. Remove faulty injector

    Remove the faulty injector.

  4. Clean injector housing seat

    Straighten and clean the seat of the injector housing in the cylinder head using an injector seat cutter tool (OEM tool reference: 9101 66000).

  5. Install new injector and tube

    Install the new injector and a new connector tube (connector tubes should generally not be reused).

  6. Reassemble and torque fittings

    Reassemble the high-pressure lines and torque all fittings to the specifications listed in the service manual.

  7. Clear codes and test run

    Clear the fault codes using the diagnostic service tool and test run the engine to ensure the fast decay error does not return.

Parts you might need

(10)
  • Fuel Injector (Common Rail)

    V837073713
  • Fuel Injector (Common Rail)

    837073713
  • Fuel Injector (Common Rail)

    0445120235
  • Injector Connector Tube

    V837073785
  • Injector Connector Tube

    F00RJ02717
  • Fuel Injector

    V837069405

    Manufactured by Bosch. Listed for MF 8650 with 84CTA engine (2008-2011).

  • Fuel InjectorV837062629

    Listed as Injector in parts list for MF 8650.

  • Fuel Injector

    7064927M91

    AGCO Parts alternative.

  • Fuel Injector

    V837069326

    AGCO Parts alternative.

Get help to fix this fault by requesting a quote

Browse other Massey Ferguson codes