Massey Ferguson E 9235 (4) – Engine Electronic Control Unit (ECU) (Sisu EEM3 or EEM4): Diagnostic ID module: ID module memory fault
Issue description
The system has detected an internal memory error in the Diagnostic ID module (IDM). This module stores vital engine-specific data, such as the serial number and specifications, required for proper Electronic Control Unit (ECU) operation. A memory fault disrupts this validation process, preventing the module from functioning correctly or storing necessary data, which may force the tractor into a reduced power mode.
Applies to these machines
9 machines- 8600 Series
- MF 8670
- MF 8690
- Sisu Tier 3
- AGCO Power Citius 44
- AGCO Power Citius 49
- AGCO Power Citius 66
- AGCO Power Citius 74
- AGCO Power Citius 84
Check the cause
Inspect the wiring harness and connector going to the Diagnostic ID module for loose contacts, corrosion, or physical damage.
Check the system for voltage spikes. A supply voltage that is too high (greater than 32.0V, often indicated by fault code E 9235 (3)) can damage the module's memory.
Connect the WinEEM3 service tool to the engine to verify communication with the ID module and confirm the memory fault is active and not a stored historical code.
Repair steps
Order replacement module
Order a new ID module. You must provide the exact engine serial number to the parts desk when ordering so the module is correctly specified for your engine.
Request ByPass code (Optional)
If the tractor needs to be operated immediately before the part arrives, contact the Sisu Diesel / AGCO Help Desk to request a 32-character ByPass code. This allows the engine to run without derating for a maximum of 200 hours.
Connect diagnostic tool
Connect the WinEEM3 service tool to the engine.
Disconnect faulty module
Physically disconnect the faulty ID module's wiring connection.
Activate ByPass (If applicable)
In the WinEEM3 software, click 'ByPass restrictions' and enter the 32-character code.
Install new module
Once the new part arrives, plug the new ID module into the harness.
Clear codes and verify
Use the WinEEM3 tool to clear the E 9235 (4) fault code and verify that the ECU recognizes the new engine serial number and specification.
Parts you might need
(5)Diagnostic ID Module (Id-Module)
837070198- Diagnostic ID Module (Id-Module)V837073491
Diagnostic ID Module (Id-Module)
83707349- Engine ID ModuleV837070201
Potential alternate part number (unconfirmed direct application).
Engine Identification Module (ID Module)
72661532
Get help to fix this fault by requesting a quote