E1136.E

Massey Ferguson E1136.E – Engine Control Unit (Engine ECU): There Is A Problem With The Engine Module Internal Temperature Sensor

Issue description

The controller has detected that its internal temperature is out of specification (extremely or moderately high), or the internal temperature sensor's signal/voltage is invalid.

Applies to these machines

  • 7616
  • 5612
  • 7622
  • Interim Tier 4 (2012-2015)
  • 7614
  • 5611
  • 7615
  • 5610
  • 5613
  • 7620
  • 5609
  • 7618
  • 5608
  • 7619
  • 7626
  • 7624
  • 4700 Series
  • 4707
  • 4708
  • 4709
  • 4710 T4
  • 5600 Series
  • 5613 iT4
  • 8600 Series
  • 5700 Series
  • 6700 Series
  • 7600 Series
  • 7700 Series

Check the cause

  1. Check airflow around the Engine ECU housing to verify proper circulation

  2. Inspect cooling systems and ensure radiator grilles are clean for sufficient fan air supply

  3. Check the engine cooling fan operation; a slow fan can cause ambient temperatures under the hood to spike, overheating the ECU

  4. Turn off the engine and allow the ECU to cool down completely to see if the fault clears

  5. Inspect the main wiring harness connectors at the ECU for corrosion, moisture, or bent pins that could cause a short or voltage irregularity (especially if sub-codes .03 or .04 are present)

Repair steps

  1. Isolate the ECU

    Disconnect the battery to prevent electrical spikes.

  2. Remove the ECU

    Unplug the main harness connectors and unbolt the Engine ECU from its mounting bracket.

  3. Determine Repair vs. Replace

    The internal temperature sensor is soldered directly onto the ECU's internal circuit board and cannot be serviced as a standalone part. You must either send the ECU to a specialized agricultural electronics repair facility for board-level repair, or replace the entire Engine ECU.

  4. Install the New/Remanufactured ECU

    Mount the new ECU and reconnect the wiring harnesses.

  5. Programming

    A new or remanufactured ECU will require programming. You must contact a Massey Ferguson dealer to flash the ECU with the correct software configuration for your tractor's specific serial number.

Parts you might need

(6)
  • Engine Control Unit (ECU) / Engine Control Module (ECM)

    Generic replacement part

  • AGCO Genuine OEM Engine Control Unit

    V836869294

    Fits MF 5710-5713 and 6711-6715 series.

  • AGCO Genuine OEM Engine Control Unit

    V837074863
  • Perkins/AGCO ECU

    4225172M1

    Fits MF 5400, 6400, 7400, 7600 series.

  • Perkins/AGCO ECU

    4225172E1

    Fits MF 5400, 6400, 7400, 7600 series.

  • Perkins ECM

    T435425

    Fits Perkins 1104C-44T engines used in models like the MF 6455.

Get help to fix this fault by requesting a quote

Browse other Massey Ferguson codes