Massey Ferguson T7137 – Transmission Control Module (TCM), TRANS, TRANS2, or VGS: Power Shuttle and Powershift Module Speed and Intermediate Speed Fault
Issue description
The transmission control module has detected a discrepancy between the expected and actual speeds of the transmission's internal components. The system continuously compares engine speed, the intermediate speed of the powershift transmission, and the final transmission output speed. When the measured output speed does not align with the calculated speed for the selected gear, this fault is registered. This condition indicates inaccurate sensor data, mechanical clutch slippage, or gear selection issues. Symptoms can include rough, delayed, or unstable gear shifts, and the illumination of a transmission warning light on the dashboard.
Applies to these machines
14 machines- 5400 series
- 5445
- 5455
- 5460
- 5465
- 5475
- 6400 series
- 6445
- 6455
- 6465
- 6475
- 6480
- 7600 series
- 7624
Check the cause
Record the exact fault code and operating conditions when it appears (e.g., during startup, under load, when warm)
Check for other related fault codes, such as those for clutch pedal sensors or solenoid circuits, which can help pinpoint the root cause
Inspect transmission and hydraulic fluid levels and condition, looking for contamination or aeration (foaming) that could indicate suction leaks
Carefully examine the wiring harnesses and connectors leading to the transmission speed sensors and the TCM for chafing, corrosion, or loose pins
Locate the intermediate speed sensor (often on the left side of the transmission housing, potentially behind the fuel tank or steps) and the transmission output speed sensor (on the top of the rear axle, reading from the crown wheel). Remove the sensors and inspect them for physical damage or metal debris on the magnetic tips
Perform sensor electrical tests: verify a 10-volt reference for Hall-effect sensors, or check resistance (450 ohms +/- 20 ohms at room temperature) and continuity for other types
Verify correct sensor adjustment (sensor should be screwed in until it contacts the gear, then backed off by approximately 3/4 of a turn before tightening the lock nut to the specified torque, e.g., 6 Nm)
Repair steps
Confirm the Fault
Use the diagnostic checks above to confirm that the fault is with a specific speed sensor or its circuit.
Access the Faulty Sensor
Depending on its location, this may require removing tractor steps, side panels, or the fuel tank.
Replace the Sensor
Disconnect the electrical connector, remove the lock nut, and unscrew the old sensor.
Install the New Sensor
Apply a thread-locking compound like Loctite 5922 to the new sensor's threads. Screw the sensor in by hand until it makes contact with the internal gear.
Set the Air Gap
Unscrew the sensor by 3/4 of a turn to set the correct air gap.
Torque the Lock Nut
Tighten the counter-nut to the manufacturer's specified torque, which may be around 6 Nm.
Reconnect and Clear Codes
Reconnect the wiring harness and clear the fault codes using a diagnostic tool.
Calibrate and Test
Some models may require a transmission calibration after replacing a speed sensor. Operate the tractor to ensure the fault does not return and that shifting performance is normal.
Parts you might need
(8)Physical length and connector type are critical for correct fitment. Verify with AGCO parts book.
Verify fitment with official AGCO parts book.
- Intermediate/Transmission Speed Sensor4226444M91
Alternate part number. Verify fitment.
Alternate part number. Verify fitment.
Intermediate/Transmission Speed Sensor
6218949M1Alternate part number. Verify fitment.
Alternate part number. Verify fitment.
- Intermediate/Transmission Speed Sensor3761983M91
Alternate part number. Verify fitment.
Transmission Control Module (TCM)
Highly specific to the tractor's model and year. Repair services for existing modules are available.
Get help to fix this fault by requesting a quote