U 2854 (19)

Massey Ferguson U 2854 (19) – Engine ECU or SCR Dosing Control Unit (DCU): CAN Rx Frame: Time out

Issue description

This code indicates a Controller Area Network (CAN) communication failure. Specifically, a control module expected to receive a specific CAN message frame (Rx = Receive) within a designated time window, but the message was not received, resulting in a "Time out." This usually points to a physical interruption on the CAN bus network, a missing terminating resistor, or a module that has stopped broadcasting.

Applies to these machines

  • Massey Ferguson 8600 Series Tractors
  • MF 8690

Check the cause

  1. Check CAN Bus Termination Resistance: With the tractor turned off and the main battery switch disconnected, use a multimeter to measure the resistance between CAN_H and CAN_L at the diagnostic port. A healthy CAN bus should read approximately 60 ohms (due to two 120-ohm terminating resistors in parallel). If it reads ~120 ohms, one terminator is missing or there is a break in the wiring. If it reads infinite/very high, the bus is completely open.

  2. Inspect Wiring and Connectors: Visually inspect the wiring harness connecting the Engine ECU to the SCR system and the tractor's main CAN bus. Look for chafed wires, moisture ingress, or loose pins.

  3. Check Power and Ground: Ensure the Engine ECU and SCR modules are receiving proper 12V/24V power and have clean, corrosion-free ground connections. A module dropping offline due to low voltage will cause a Rx Time out.

  4. Run EDT Diagnostics: Connect the AGCO Electronic Diagnostic Tool (EDT) to view live CAN bus traffic and determine exactly which module is failing to broadcast.

Repair steps

  1. Disconnect Power

    Turn off the tractor and disconnect the negative battery terminal to prevent electrical spikes during repair.

  2. Isolate the Fault

    If your multimeter reading was 120 ohms, locate the CAN bus terminating resistors (often found under plastic covers near the rear ISOBUS socket, inside the cab near the diagnostic port, or near the ECU).

  3. Repair Wiring / Replace Resistor

    If a terminating resistor is missing, damaged, or corroded, replace it with a new OEM terminator. If the wiring harness is damaged, splice and repair the CAN_H and CAN_L wires using twisted-pair wire to prevent electromagnetic interference, or replace the affected harness section.

  4. Clean Connections

    Disconnect the Engine ECU and SCR DCU connectors. Spray them with a high-quality electrical contact cleaner, ensure no pins are pushed back, and apply dielectric grease before reconnecting.

  5. Clear Codes

    Reconnect the battery, turn the key to the ON position, and use the AGCO EDT to clear the inactive U 2854 (19) fault code from the memory.

Parts you might need

(5)
  • CAN-BUS Terminator

    526200D1
  • 120-ohm CAN bus terminating resistor

  • Twisted-pair CAN wire

  • Deutsch 2-pin/9-pin connectors

Get help to fix this fault by requesting a quote

Browse other Massey Ferguson codes