U 2870 (2)

Massey Ferguson U 2870 (2) – ECU / TCM: Vehicle Speed CAN Range Error

Issue description

This fault code indicates a communication error on the Controller Area Network (CAN) bus. The Engine Control Unit (ECU) or Transmission Control Module (TCM) is receiving a vehicle speed signal that falls outside of the expected, plausible, or programmed operating range. The (2) Failure Mode Indicator designates that the data being received is erratic, intermittent, or incorrect.

Applies to these machines

  • 8600 Series
  • 8650
  • 8660
  • 8670
  • 8680
  • 8690
  • 6400 Series
  • 7700 Series

Check the cause

  1. Inspect the vehicle speed sensor (often mounted on the transmission housing or collecting shaft) for physical damage, heavy dirt/debris buildup, or metallic shavings on the magnetic tip.

  2. Check the wiring harness between the speed sensor and the ECU/TCM for chafed wires, melted insulation, or pinched lines.

  3. Disconnect the speed sensor and inspect the connector pins for corrosion, moisture, or poor terminal tension.

  4. Perform a CAN Bus network test: check the CAN High and CAN Low lines for proper voltage and resistance (a healthy CAN bus typically reads 60 ohms across the network with the battery disconnected).

  5. Check for concurrent transmission or wheel speed sensor codes. If multiple sensors are dropping out, the issue is likely a shared ground or a broader CAN bus failure rather than a single sensor.

Repair steps

  1. Power down machine

    Turn off the ignition and disconnect the negative battery cable to prevent electrical shorts.

  2. Locate the sensor

    Locate the faulty vehicle/road speed sensor on the transmission block.

  3. Remove the sensor

    Unplug the electrical connector. Remove the retaining bolt holding the sensor in place and carefully pull the sensor out of its bore.

  4. Clean the port

    Wipe the mounting surface and bore clean. Ensure no dirt falls into the transmission housing.

  5. Install the new sensor

    Insert the new OEM speed sensor. Install the retaining bolt and tighten it to the manufacturer's specified torque.

  6. Reconnect wiring

    Plug the electrical connector back in, ensuring it clicks securely into place.

  7. Test and clear codes

    Reconnect the battery. Turn on the tractor and use an AGCO Electronic Diagnostic Tool (EDT) to clear the U 2870 (2) fault code. Test drive the tractor to ensure the speedometer registers correctly and the code does not return.

Parts you might need

(5)

Get help to fix this fault by requesting a quote

Browse other Massey Ferguson codes