U 2870 (9)

Massey Ferguson U 2870 (9) – Transmission control unit, Engine ECU, or main vehicle controller: CAN Frame Error: Message overridden

Issue description

The Controller Area Network (CAN) bus is experiencing communication issues—specifically, a data frame (likely related to vehicle speed data) is being overwritten or corrupted before it can be properly processed by the receiving module.

Applies to these machines

  • 8600 Series
  • MF 8650
  • MF 8660
  • MF 8670
  • MF 8680
  • MF 8690

Check the cause

  1. Scan for related codes such as U 2870 (2) 'Range error of Vehicle speed' or U 2870 (19) 'Time out', which point directly to a vehicle speed sensor communication failure.

  2. Inspect the CAN bus wiring harness for physical damage, chafing, or short circuits.

  3. Use an AGCO CANUSB interface or a 7-pin to 16-pin diagnostic cable to monitor CAN bus traffic and verify if messages are actively dropping or being overridden.

  4. Verify the integrity of the CAN bus terminators, as faulty terminators can cause message reflection and frame errors.

Repair steps

  1. Disconnect battery

    Disconnect the tractor's battery before performing electrical repairs.

  2. Locate harness

    Locate the section of the CAN bus harness communicating vehicle speed data.

  3. Replace harness

    If the wiring harness is damaged, replace the affected harness section using the appropriate OEM extension or replacement harness.

  4. Replace terminator

    If the CAN bus terminator is faulty (causing the overridden messages), unplug the old terminator and install a new OEM CANBUS terminator.

  5. Test and clear codes

    Reconnect the battery, clear the DTCs using the Massey Ferguson diagnostic tool, and test drive the tractor to ensure the vehicle speed registers correctly and the U 2870 (9) code does not return.

Parts you might need

(5)

Get help to fix this fault by requesting a quote

Browse other Massey Ferguson codes