U 2871 (19)

Massey Ferguson U 2871 (19) – Instrument Panel (X55) or Engine Control Unit (ECU) / DCC3: CAN Frame Time Date Error: Time out

Issue description

A control module on the tractor's Controller Area Network (CAN) bus has received a time and date message frame that falls outside of the expected, valid, or programmed parameters. It is a communication and data validity error rather than a mechanical failure.

Applies to these machines

  • Massey Ferguson 8600 Series
  • Massey Ferguson 8650
  • Massey Ferguson 8660
  • Massey Ferguson 8670
  • Massey Ferguson 8680
  • Massey Ferguson 8690
  • AGCO machines equipped with the Sisu Tier 3 engine

Check the cause

  1. Verify battery voltage and connections, as low voltage or voltage spikes can cause CAN communication drops and trigger timeout errors.

  2. Inspect the CAN bus wiring harness (specifically the instrument panel harness and cab transmission harness) for chafing, breaks, or short circuits.

  3. Check the connectors at the Instrument Panel (X55) and the ECU for corrosion, moisture ingress, or backed-out pins.

  4. Test the CAN bus terminating resistors with a multimeter (with the battery disconnected, the CAN network should typically read around 60 ohms across CAN High and CAN Low).

Repair steps

  1. Disconnect Power

    Turn off the tractor and disconnect the negative battery terminal to prevent electrical shorts during repair.

  2. Access the Modules

    Remove the necessary trim panels to access the rear of the Instrument Panel and the Engine ECU.

  3. Clean and Reseat Connectors

    Disconnect the CAN bus connectors. Spray them with a high-quality electrical contact cleaner, allow them to dry, and firmly reconnect them to ensure a solid connection.

  4. Repair Wiring

    If any damaged wires were found during the diagnostic phase, splice and solder the wires, then seal them with heat-shrink tubing.

  5. Clear Codes

    Reconnect the battery. Connect a diagnostic tool to the tractor's diagnostic port and clear the U 2871 (19) fault code.

  6. Test Operation

    Start the tractor and monitor the instrument panel. If the code returns immediately, the internal CAN transceiver in the Instrument Panel or ECU may be faulty, requiring module replacement or a software re-flash by a dealer.

Parts you might need

(9)
  • Instrument Panel (DCC3)

    4353089M91
  • CAN Bus Wiring Harness

  • Engine Control Unit (ECU)

  • CAN Terminating Resistor

  • Main Tractor Wiring Harness (MF 8600 Series)

    4348225M91
  • CANBUS Extension Wire Harness

    ACX3672860

Get help to fix this fault by requesting a quote

Browse other Massey Ferguson codes