Massey Ferguson U 441 (0) – Engine ECU / SCR System Module: Catalyst downstream temperature sensor: Temperature too high
Issue description
This code indicates that the control module is receiving an abnormally high voltage signal from the exhaust gas temperature sensor located downstream of the catalytic converter. A 'Shortcut to Battery+' means the sensor's signal circuit is shorted directly to a power source (such as a 12V or 5V reference wire), or the sensor has suffered an internal failure causing it to return maximum voltage. This condition can prevent the system from initiating active regeneration, potentially leading to filter clogging or a derated power mode.
Applies to these machines
9 machines- Massey Ferguson 8600 Series
- MF 8650
- MF 8660
- MF 8670
- MF 8680
- MF 8690
- Massey Ferguson 5700 Series
- Massey Ferguson 6700 Series
- Massey Ferguson 7700 Series
Check the cause
Check for related electrical fault codes (e.g., U 441 (3) for short to battery or U 441 (4) for short to ground) to rule out wiring harness issues.
Visually inspect the wiring harness and connector leading to the downstream temperature sensor for melted wires, chafing, or corrosion.
Unplug the sensor and perform a resistance test using a multimeter. Compare the reading against OEM specifications to determine if the sensor is internally shorted.
Perform a physical temperature check to ensure the SCR system is not actually overheating due to a blocked catalyst or a malfunctioning DEF/AdBlue dosing injector.
Repair steps
Safety First
Park the tractor on a level surface, turn off the engine, and allow the exhaust system to cool completely. Exhaust components operate at extreme temperatures and can cause severe burns.
Disconnect Power
Disconnect the negative (-) battery terminal to prevent electrical spikes and ensure safety during the repair.
Locate the Sensor
Locate the downstream exhaust gas temperature sensor. It is threaded directly into the exhaust pipe immediately after the SCR catalytic converter.
Disconnect the Harness
Unplug the sensor's electrical connector from the main engine/emissions wiring harness.
Remove the Sensor
Using a suitable wrench or a specialized sensor socket, carefully unscrew the sensor from the exhaust pipe. Note: Because of extreme heat cycling, the sensor may be seized. Penetrating oil may be required.
Install the New Sensor
Apply a small amount of high-temperature anti-seize compound to the threads of the new sensor (be careful not to get any on the sensor probe itself). Thread it into the exhaust pipe and tighten it securely.
Reconnect
Plug the electrical connector back into the wiring harness and reconnect the negative battery terminal.
Clear Codes
Connect a diagnostic tool to the tractor's OBD/diagnostic port, clear the U 441 (0) fault code from the ECU, and run the engine to verify the code does not return.
Parts you might need
(11)Anti-pollution system temperature sensor / Exhaust Gas Temperature (EGT) Sensor (Downstream)
4386649M1Anti-pollution system temperature sensor / Exhaust Gas Temperature (EGT) Sensor (Downstream)
SKT-1019Catalyst downstream temperature sensor / Exhaust Gas Temperature (EGT) sensor
4295038M1Catalyst downstream temperature sensor / Exhaust Gas Temperature (EGT) sensor
4355277M2- Exhaust Manifold Temperature Sensor4226446M91
Catalyst downstream temperature sensor / Exhaust Gas Temperature (EGT) sensor
197869Exhaust System Temperature Sensor (Downstream)
AGCO ACW2167060
Get help to fix this fault by requesting a quote