U 700 (5)

Massey Ferguson U 700 (5) – SCR Controller / Engine ECU: Pressure line heater power stage error: Open load

Issue description

The Engine Control Unit (ECU) has detected a short circuit to the battery positive (12V/24V) on the power stage (control circuit) for the DEF (Diesel Exhaust Fluid / AdBlue) pressure line heater. The pressure line heater is an electrically heated element built into the DEF line to prevent the fluid from freezing between the DEF supply pump and the dosing injector. A "Shortcut to Battery+" means the circuit is receiving constant voltage when it shouldn't be, usually due to a wiring short or an internally shorted heater element.

Applies to these machines

  • Massey Ferguson 8600 Series
  • Massey Ferguson 8650
  • Massey Ferguson 8660
  • Massey Ferguson 8670
  • Massey Ferguson 8680
  • Massey Ferguson 8690
  • Massey Ferguson 7600 Series
  • Massey Ferguson S/S3 Series

Check the cause

  1. Visually inspect the DEF pressure line (from the DEF tank/pump module to the dosing injector) and wiring harness for physical damage, kinks, or chafing.

  2. Disconnect the electrical plug for the pressure line heater and inspect the pins for corrosion, moisture, or pushed-out terminals.

  3. Perform a continuity test using a digital multimeter across the heater element pins on the pressure line itself. If the multimeter reads 'OL' (Open Loop) or infinite resistance, the heating element is burnt out.

  4. If the line has continuity, test the tractor-side wiring harness back to the SCR controller for a broken wire.

Repair steps

  1. Preparation

    Turn off the tractor, remove the key, and disconnect the battery. Ensure the exhaust and SCR system have completely cooled.

  2. Disconnect Electricals

    Unplug the electrical connector for the DEF pressure line heater.

  3. Disconnect Fluid Lines

    Release the quick-connect hydraulic fittings on both ends of the DEF pressure line (at the pump module and at the dosing injector). Note: Have a clean rag ready, as some DEF fluid will spill. Clean any spilled DEF immediately with warm water, as it is highly corrosive to metal and wiring.

  4. Remove the Line

    Carefully unclip the faulty heated line from its routing brackets.

  5. Install the New Line

    Route the new heated pressure line exactly as the old one was routed. Ensure it is kept away from sharp edges, moving parts, and direct contact with extreme exhaust heat to prevent future chafing or melting.

  6. Reconnect

    Snap the quick-connect fluid fittings into place (ensure the O-rings are seated properly to prevent air ingress) and plug in the electrical connector.

  7. Clear Codes and Test

    Reconnect the battery. Turn the ignition on and use a diagnostic scan tool to clear the U 700 (5) fault code. Start the engine and allow the SCR system to prime; verify there are no DEF leaks and that the code does not return.

Parts you might need

(2)

Get help to fix this fault by requesting a quote

Browse other Massey Ferguson codes