X109

Massey Ferguson X109 – Armrest: FingerTIP 4 Fault

Issue description

The fault code indicates an electrical malfunction with the FingerTIP 4 electronic switch located on the tractor's armrest. This fault is logged by the armrest control module (Armrest Autotronic 5) and typically points to a short circuit, open circuit, or calibration issue within the switch or its wiring circuit.

Applies to these machines

  • 8600
  • 5S
  • 6S
  • 7S
  • 8S
  • 9S
  • 6400
  • 7600
  • 7700
  • 7700S

Check the cause

  1. Visually inspect the wiring harness leading to and within the armrest for chafing, pinching, or damage.

  2. Disconnect and inspect electrical connectors for the armrest controller and FingerTIP controls for corrosion, moisture, or pushed-out pins. Clean any corrosion found and ensure the connectors are securely seated upon reassembly.

  3. Verify the armrest control module has a stable, clean power supply and a solid ground connection.

  4. Perform a wiggle test on the wiring harness with the system powered on to check for intermittent connections or breaks.

Repair steps

  1. Access armrest internals

    Disassemble the armrest to gain access to the internal electronic components and wiring.

  2. Disconnect faulty switch

    Identify the FingerTIP 4 switch and disconnect it from the associated wiring harness.

  3. Replace component

    Replace the faulty FingerTIP 4 switch with a new OEM component.

  4. Reassemble armrest

    Securely reassemble the armrest housing and ensure all wiring is safely routed to prevent pinching.

  5. Calibrate component

    Perform a calibration of the new FingerTIP 4 component if required by the specific tractor model.

Parts you might need

(3)
  • FingerTIP 4 electronic switch

    Confirm correct electronic switch part number with a dealer using the tractor's serial number.

  • Finger4300117M92

    Alternate PN: 4300117M91. Note: May be a mechanical transmission component rather than the electronic armrest switch. Verify before purchase.

  • Finger

    4-1207-0228-0

    AGCO part, fitment unconfirmed. Verify with dealer.

Get help to fix this fault by requesting a quote

Browse other Massey Ferguson codes