Massey Ferguson X110 – Armrest: FingerTIP 5 Fault
Issue description
The fault code X110 indicates an electrical issue with the FingerTIP 5 control within the armrest control circuit, which operates hydraulic functions. The controller has detected that the signal wire for the FingerTIP 5 control is either electrically shorted to ground (often accompanied by code AR 51) or shorted to a 12-volt power source (often accompanied by code AR 52). This is an electrical circuit failure, not a mechanical issue.
Applies to these machines
8 machines- 8600
- 5600
- 6600
- 7600
- 7700
- 8700
- 5700 S
- 6700 S
Check the cause
Record and clear faults (noting if AR 51 or AR 52 is present) to see if the code returns immediately, indicating a persistent short.
Visually inspect the armrest control unit, joystick, and fingertip levers for visible damage, worn wiring, loose connectors, or moisture ingress.
Examine the wiring harness running to and from the armrest controller for chafing against the chassis, and check main electrical connectors for corrosion or bent pins.
Identify the 'FingerTIP 5' circuit by accessing the armrest controller's electrical connectors to test the specific pins related to this circuit (identified as connector X110).
If AR 51 (Short to Ground) is suspected: Disconnect the armrest controller and switch, then measure resistance between the X110 signal wire and chassis ground (a reading near zero ohms confirms the short).
If AR 52 (Short to Power) is suspected: With the key on and engine off, disconnect the switch connector and measure voltage between the harness signal wire and chassis ground (a reading of 12V confirms the short).
Repair steps
Isolate the fault
Based on the electrical diagnostic checks, determine whether the short circuit is located in the wiring harness, a connector, or the FingerTIP 5 component itself.
Repair wiring harness
If a chafed or damaged wire is found in the harness, repair the section using appropriate splicing and heat-shrinking techniques. Reroute the harness to prevent future rubbing.
Repair connectors
If the fault is isolated to a connector, clean any corrosion using electrical contact cleaner, straighten bent pins, and ensure the connector is securely latched.
Replace armrest control component
If diagnostics confirm the FingerTIP 5 switch or joystick is internally shorted, replace the affected joystick or control armrest assembly.
Parts you might need
(2)AGCO OEM part. Compatible with multiple series (5600, 5700 S, 6600, 6700 S, 7600, 7700). Confirm fitment with serial number.
- Armrest switch kitF835970160061
Alternative replacement part; confirm exact requirement with dealer.
Get help to fix this fault by requesting a quote