X48

Massey Ferguson X48 – CSC / DCC3: Fault in Rear Left-Hand Unit for Suspended Cab

Issue description

The control module has detected an electrical problem with the wiring or components of the rear left-hand suspension unit for the suspended cab. This fault indicates a failure in the sensing cylinder, wiring harness, or suspension block, which can prevent the cab suspension system from operating or calibrating correctly.

Applies to these machines

  • 8600 Series
  • 8650
  • 8670
  • 6400 Series
  • 7400 Series
  • 8400 Series
  • 5600 Series
  • 5700 Series
  • 7700 Series

Check the cause

  1. Visually inspect the wiring harness leading to the rear left-hand cab suspension unit for chafing, corrosion, or loose connections

  2. Use a multimeter to check for continuity (open circuits) and shorts to power (+12V) or ground in the wiring harness

  3. Monitor the signal from the cab suspension's position sensors using diagnostic software; an unsteady signal when stationary indicates a failing sensing cylinder

  4. Check for symptoms matching service bulletin 17-0031, where loose SRE1 and SRE2 restrictors in the cab suspension block cause the cab to move up and down constantly

  5. Attempt to recalibrate the cab suspension by pressing the cab suspension button five or six times. Failure to calibrate indicates a persistent fault

Repair steps

  1. Secure the cab

    Raise the cab to its maximum height using a calibration procedure or service mode, and securely block it in place to prevent it from dropping unexpectedly.

  2. Address Service Bulletin 17-0031

    If the cab moves up and down constantly (restrictor issue), locate the cab suspension block and replace the existing restrictor plugs with the updated, longer plugs (kit ACW1748270).

  3. Repair wiring harness

    Repair or replace any damaged sections of the wiring harness identified during the electrical continuity and short-circuit checks.

  4. Replace faulty suspension components

    Replace the rear left-hand sensing cylinder unit if sensor signals are erratic. If the cab suspension block is damaged, replace the entire block assembly (ACW1697500).

  5. Calibrate cab suspension

    Perform the cab suspension calibration procedure. The indicator light should turn solid green when the calibration is successful.

Parts you might need

(5)
  • Longer plugs to resolve loose restrictors per service bulletin 17-0031

  • Complete hydraulic block, includes updated longer plugs

  • 12V air compressor. Alternate part numbers: 4275812M91, 4275812M92, 4288258M1, 4288271M1

  • Rear Left-Hand Sensing Cylinder/Suspension Unit

    Contact dealer with tractor serial number for exact part

  • Aftermarket Sensor

    280381-2

    Used to repair older, unreliable sensing cylinders. Alternate part: CM0109V

Get help to fix this fault by requesting a quote

Browse other Massey Ferguson codes