X97

Massey Ferguson X97 – Autotronic 5 Linkage control module: Left-Hand Fender Switch Incorrect Signal

Issue description

The linkage control module has detected an electrical signal from the left-hand fender switch (component X97) that is outside of its expected parameters. This incorrect signal can be caused by an open circuit, a short circuit, or an internal failure of the switch itself. Because the system cannot reliably determine the operator's command, it deactivates the fender control function as a safety precaution.

Applies to these machines

  • 5400 Series
  • 6400 Series
  • 7600 Series
  • Global Series

Check the cause

  1. Verify the active fault code using the tractor's diagnostic display or flashing lights (look for code R 15 or flash code 15).

  2. Visually inspect the left-hand fender switch (X97) for physical damage, water ingress, or corrosion in the connector.

  3. Inspect the wiring harness leading from the switch for visible damage, chafing against the chassis, or pinch points.

  4. Ensure the battery is fully charged and that all primary power and ground connections are clean and tight, as low voltage can cause erratic behavior.

  5. Attempt a switch activation sequence (e.g., up-down-up-down, then press and hold) if applicable to your model (such as the Global Series) to rule out an inactive state.

  6. Disconnect the electrical connector at the fender switch and inspect the pins and terminals for corrosion, moisture, or damage. Clean with electrical contact cleaner if necessary and ensure a secure connection when reassembled.

Repair steps

  1. Disconnect the switch

    Disconnect the wiring harness from the faulty left-hand fender switch (X97).

  2. Test the switch

    Using a multimeter set to continuity or resistance mode, connect the probes to the switch's terminals and test the internal function. Actuate the 'lift' and 'lower' functions. The multimeter should show a change in state (from open to closed circuit, or a significant change in resistance) when pressed, and return to its original state when released. If the switch fails to show a change in state or is permanently open or closed, replace it.

  3. Test the wiring harness

    With the switch disconnected and the ignition on, use a multimeter to check for reference voltage (typically 5V or 12V) at the harness connector. Check the ground pin for good continuity to the chassis ground. If voltage or ground is missing, trace the affected wire back towards the controller to repair breaks or shorts. A wiring diagram for the specific tractor model is highly recommended for this step.

  4. Isolate intermittent faults

    Wiggle the harness while testing to see if the fault can be reproduced. If the fault persists and all wiring and switch functions are confirmed intact, the linkage control module itself may require professional diagnosis by a dealer.

Parts you might need

(5)
  • Verify correct part number with an authorized dealer using the tractor's serial number.

  • Lift Switch Up/Down

    4290447M2

    Verify correct part number with an authorized dealer using the tractor's serial number.

  • Verify correct part number with an authorized dealer using the tractor's serial number.

  • Hitch Up SwitchACW151746A

    Verify correct part number with an authorized dealer using the tractor's serial number.

  • Verify correct part number with an authorized dealer using the tractor's serial number.

Get help to fix this fault by requesting a quote

Browse other Massey Ferguson codes